From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: from kirsty.vergenet.net ([202.4.237.240]:56273 "EHLO kirsty.vergenet.net" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1726233AbfC0MIF (ORCPT ); Wed, 27 Mar 2019 08:08:05 -0400 Date: Wed, 27 Mar 2019 13:08:01 +0100 From: Simon Horman Subject: Re: [PATCH 1/2] ARM: dts: rskrza1: Add I2C support Message-ID: <20190327120801.2klhf4wzob57kuik@verge.net.au> References: <20190320194410.14870-1-geert+renesas@glider.be> <20190320194410.14870-2-geert+renesas@glider.be> <20190322102324.yxnrwnkyhxrzqdg4@verge.net.au> MIME-Version: 1.0 Content-Type: text/plain; charset=us-ascii Content-Disposition: inline In-Reply-To: Sender: devicetree-owner@vger.kernel.org To: Geert Uytterhoeven Cc: Geert Uytterhoeven , Magnus Damm , Chris Brandt , Linux-Renesas , "open list:OPEN FIRMWARE AND FLATTENED DEVICE TREE BINDINGS" List-ID: On Mon, Mar 25, 2019 at 11:55:50AM +0100, Geert Uytterhoeven wrote: > Hi Simon, > > On Fri, Mar 22, 2019 at 11:23 AM Simon Horman wrote: > > On Wed, Mar 20, 2019 at 08:44:09PM +0100, Geert Uytterhoeven wrote: > > > Enable the I2C bus, and add the following devices: > > > - Two CAT9554 port expanders (8 GPIOs, interrupt not wired by > > > default), > > > - R1EX24016ASAS0A EEPROM. > > > > > > The bus also contains a MAX9856 Audio Codec, which is not yet supported. > > > > > > All devices (incl. the audio codec) are documented to support an I2C bus > > > running at 400 kHz. > > > > > > Pinctrl is based on the RZ/A BSP. > > > > > > Signed-off-by: Geert Uytterhoeven > > > --- > > > Pending acceptance of the DT binding patches documenting the > > > "onnn,cat9554" and "renesas,r1ex24016" compatible values. > > > > Thanks. > > > > I'm marking this series as deferred pending acceptance of the bindings. > > Please repost or ping me once that has happened. > > next-20190325 has: > > d333bad1f6f3e0df dt-bindings: at24: add Renesas R1EX24016 > 5c9f8cfe3cb67dcb dt-bindings: gpio: pca953x: Document onnn,cat9554 Thanks, applied for v5.2.