From mboxrd@z Thu Jan 1 00:00:00 1970 From: Guillaume La Roque Subject: [PATCH v4 1/6] dt-bindings: pinctrl: add a 'drive-strength-microamp' property Date: Thu, 9 May 2019 18:28:54 +0200 Message-ID: <20190509162859.7001-2-glaroque@baylibre.com> References: <20190509162859.7001-1-glaroque@baylibre.com> Return-path: In-Reply-To: <20190509162859.7001-1-glaroque@baylibre.com> Sender: linux-kernel-owner@vger.kernel.org To: linus.walleij@linaro.org, khilman@baylibre.com Cc: jbrunet@baylibre.com, linux-gpio@vger.kernel.org, devicetree@vger.kernel.org, linux-amlogic@lists.infradead.org, linux-kernel@vger.kernel.org List-Id: devicetree@vger.kernel.org This property allow drive-strength parameter in uA instead of mA. Signed-off-by: Guillaume La Roque --- Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt | 3 +++ 1 file changed, 3 insertions(+) diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt index cef2b5855d60..84adce9f2a75 100644 --- a/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt +++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt @@ -258,6 +258,7 @@ drive-push-pull - drive actively high and low drive-open-drain - drive with open drain drive-open-source - drive with open source drive-strength - sink or source at most X mA +drive-strength-microamp - sink or source at most X uA input-enable - enable input on pin (no effect on output, such as enabling an input buffer) input-disable - disable input on pin (no effect on output, such as @@ -326,6 +327,8 @@ arguments are described below. - drive-strength takes as argument the target strength in mA. +- drive-strength-uA takes as argument the target strength in uA. + - input-debounce takes the debounce time in usec as argument or 0 to disable debouncing -- 2.17.1