Re: [PATCH] media: dt-bindings: rcar_vin: Document RZ/G1 per-board settings

["Niklas Söderlund" <niklas.soderlund+renesas@ragnatech.se>]

Hi Geert,

Thanks for your work.

On 2019-10-24 15:14:23 +0200, Geert Uytterhoeven wrote:
> The R-Car Gen2 per-board settings apply to RZ/G1, too.
> 
> Fixes: 1d14a5eaa156b0b3 ("media: dt-bindings: media: rcar_vin: add device tree support for r8a774[35]")
> Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>

Reviewed-by: Niklas Söderlund <niklas.soderlund+renesas@ragnatech.se>

> ---
>  Documentation/devicetree/bindings/media/renesas,vin.txt | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/media/renesas,vin.txt b/Documentation/devicetree/bindings/media/renesas,vin.txt
> index aa217b0962797712..221fcc416d1ac598 100644
> --- a/Documentation/devicetree/bindings/media/renesas,vin.txt
> +++ b/Documentation/devicetree/bindings/media/renesas,vin.txt
> @@ -43,7 +43,7 @@ on Gen3 and RZ/G2 platforms to a CSI-2 receiver.
>  Additionally, an alias named vinX will need to be created to specify
>  which video input device this is.
>  
> -The per-board settings Gen2 platforms:
> +The per-board settings for Gen2 and RZ/G1 platforms:
>  
>  - port - sub-node describing a single endpoint connected to the VIN
>    from external SoC pins as described in video-interfaces.txt[1].
> @@ -63,7 +63,7 @@ The per-board settings Gen2 platforms:
>      - data-enable-active: polarity of CLKENB signal, see [1] for
>        description. Default is active high.
>  
> -The per-board settings Gen3 and RZ/G2 platforms:
> +The per-board settings for Gen3 and RZ/G2 platforms:
>  
>  Gen3 and RZ/G2 platforms can support both a single connected parallel input
>  source from external SoC pins (port@0) and/or multiple parallel input sources
> -- 
> 2.17.1
> 

-- 
Regards,
Niklas Söderlund