[PATCH v2 0/6] net: phy: at803x device tree binding

[Michael Walle <michael@walle.cc>]

Adds a device tree binding to configure the clock and the RGMII voltage.

Changes since v1:
 - rebased to latest net-next
 - renamed "Atheros" to "Qualcomm Atheros"
 - add a new patch to remove config_init() from AR9331

Changes since the RFC:
 - renamed the Kconfig entry to "Qualcomm Atheros.." and reordered the
   item
 - renamed the prefix from atheros to qca
 - use the correct name AR803x (instead of AT803x) in new files and
   dt-bindings.
 - listed the PHY maintainers in the new schema. Hopefully, thats ok.
 - fixed a typo in the bindings schema
 - run dtb_checks and dt_binding_check and fixed the schema
 - dropped the rgmii-io-1v8 property; instead provide two regulators vddh
   and vddio, add one consumer vddio-supply
 - fix the clock settings for the AR8030/AR8035
 - only the AR8031 supports chaning the LDO and the PLL mode in software.
   Check if we have the correct PHY.
 - new patch to mention the AR8033 which is the same as the AR8031 just
   without PTP support
 - new patch which corrects any displayed PHY names and comments. Be
   consistent.

Michael Walle (6):
  net: phy: at803x: fix Kconfig description
  dt-bindings: net: phy: Add support for AT803X
  net: phy: at803x: add device tree binding
  net: phy: at803x: mention AR8033 as same as AR8031
  net: phy: at803x: fix the PHY names
  net: phy: at803x: remove config_init for AR9331

 .../devicetree/bindings/net/qca,ar803x.yaml   | 111 ++++++
 MAINTAINERS                                   |   2 +
 drivers/net/phy/Kconfig                       |  10 +-
 drivers/net/phy/at803x.c                      | 321 +++++++++++++++++-
 include/dt-bindings/net/qca-ar803x.h          |  13 +
 5 files changed, 441 insertions(+), 16 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/net/qca,ar803x.yaml
 create mode 100644 include/dt-bindings/net/qca-ar803x.h

-- 
2.20.1