[PATCH v3 3/5] phy: qcom: qmp: Use power_on/off ops for PCIe

[Bjorn Andersson <bjorn.andersson@linaro.org>]

The PCIe PHY initialization requires the attached device to be present,
which is primarily achieved by the PCI controller driver.  So move the
logic from init/exit to power_on/power_off.

Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
---

Changes since v2:
- None

 drivers/phy/qualcomm/phy-qcom-qmp.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/phy/qualcomm/phy-qcom-qmp.c b/drivers/phy/qualcomm/phy-qcom-qmp.c
index 66f91726b8b2..b9f849d86795 100644
--- a/drivers/phy/qualcomm/phy-qcom-qmp.c
+++ b/drivers/phy/qualcomm/phy-qcom-qmp.c
@@ -1968,7 +1968,7 @@ static const struct phy_ops qcom_qmp_phy_gen_ops = {
 	.owner		= THIS_MODULE,
 };
 
-static const struct phy_ops qcom_qmp_ufs_ops = {
+static const struct phy_ops qcom_qmp_pcie_ufs_ops = {
 	.power_on	= qcom_qmp_phy_enable,
 	.power_off	= qcom_qmp_phy_disable,
 	.set_mode	= qcom_qmp_phy_set_mode,
@@ -2068,8 +2068,8 @@ int qcom_qmp_phy_create(struct device *dev, struct device_node *np, int id)
 		}
 	}
 
-	if (qmp->cfg->type == PHY_TYPE_UFS)
-		ops = &qcom_qmp_ufs_ops;
+	if (qmp->cfg->type == PHY_TYPE_UFS || qmp->cfg->type == PHY_TYPE_PCIE)
+		ops = &qcom_qmp_pcie_ufs_ops;
 
 	generic_phy = devm_phy_create(dev, np, ops);
 	if (IS_ERR(generic_phy)) {
-- 
2.23.0