* [PATCHv5 01/14] dt-bindings: remoteproc: Add OMAP remoteproc bindings
[not found] <20200116135332.7819-1-t-kristo@ti.com>
@ 2020-01-16 13:53 ` Tero Kristo
2020-01-22 2:34 ` Rob Herring
0 siblings, 1 reply; 2+ messages in thread
From: Tero Kristo @ 2020-01-16 13:53 UTC (permalink / raw)
To: bjorn.andersson, ohad, linux-remoteproc
Cc: linux-kernel, mathieu.poirier, s-anna, linux-omap, Rob Herring,
devicetree, Tero Kristo
From: Suman Anna <s-anna@ti.com>
Add the device tree bindings document for the IPU and DSP
remote processor devices on OMAP4+ SoCs.
Cc: Rob Herring <robh@kernel.org>
Cc: devicetree@vger.kernel.org
Signed-off-by: Suman Anna <s-anna@ti.com>
[t-kristo@ti.com: converted to schema]
Signed-off-by: Tero Kristo <t-kristo@ti.com>
---
v5:
- enforced ordering of reg-names
- removed ti,bootreg-shift, instead added this under ti,bootreg
property
- renamed ti,autosuspend-delay to ti,autosuspend-delay-ms
- fixed required property handling
- fixed the omap5 ipu example firmware name extension
.../remoteproc/ti,omap-remoteproc.yaml | 322 ++++++++++++++++++
1 file changed, 322 insertions(+)
create mode 100644 Documentation/devicetree/bindings/remoteproc/ti,omap-remoteproc.yaml
diff --git a/Documentation/devicetree/bindings/remoteproc/ti,omap-remoteproc.yaml b/Documentation/devicetree/bindings/remoteproc/ti,omap-remoteproc.yaml
new file mode 100644
index 000000000000..b910aac7895e
--- /dev/null
+++ b/Documentation/devicetree/bindings/remoteproc/ti,omap-remoteproc.yaml
@@ -0,0 +1,322 @@
+# SPDX-License-Identifier: (GPL-2.0-only or BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/remoteproc/ti,omap-remoteproc.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: OMAP4+ Remoteproc Devices
+
+maintainers:
+ - Suman Anna <s-anna@ti.com>
+
+description:
+ The OMAP family of SoCs usually have one or more slave processor sub-systems
+ that are used to offload some of the processor-intensive tasks, or to manage
+ other hardware accelerators, for achieving various system level goals.
+
+ The processor cores in the sub-system are usually behind an IOMMU, and may
+ contain additional sub-modules like Internal RAM and/or ROMs, L1 and/or L2
+ caches, an Interrupt Controller, a Cache Controller etc.
+
+ The OMAP SoCs usually have a DSP processor sub-system and/or an IPU processor
+ sub-system. The DSP processor sub-system can contain any of the TI's C64x,
+ C66x or C67x family of DSP cores as the main execution unit. The IPU processor
+ sub-system usually contains either a Dual-Core Cortex-M3 or Dual-Core
+ Cortex-M4 processors.
+
+ Each remote processor sub-system is represented as a single DT node. Each node
+ has a number of required or optional properties that enable the OS running on
+ the host processor (MPU) to perform the device management of the remote
+ processor and to communicate with the remote processor. The various properties
+ can be classified as constant or variable. The constant properties are
+ dictated by the SoC and does not change from one board to another having the
+ same SoC. Examples of constant properties include 'iommus', 'reg'. The
+ variable properties are dictated by the system integration aspects such as
+ memory on the board, or configuration used within the corresponding firmware
+ image. Examples of variable properties include 'mboxes', 'memory-region',
+ 'timers', 'watchdog-timers' etc.
+
+properties:
+ compatible:
+ enum:
+ - ti,omap4-dsp
+ - ti,omap5-dsp
+ - ti,dra7-dsp
+ - ti,omap4-ipu
+ - ti,omap5-ipu
+ - ti,dra7-ipu
+
+ iommus:
+ minItems: 1
+ maxItems: 2
+ description: |
+ phandles to OMAP IOMMU nodes, that need to be programmed
+ for this remote processor to access any external RAM memory or
+ other peripheral device address spaces. This property usually
+ has only a single phandle. Multiple phandles are used only in
+ cases where the sub-system has different ports for different
+ sub-modules within the processor sub-system (eg: DRA7 DSPs),
+ and need the same programming in both the MMUs.
+
+ mboxes:
+ minItems: 1
+ maxItems: 2
+ description: |
+ OMAP Mailbox specifier denoting the sub-mailbox, to be used for
+ communication with the remote processor. The specifier format is
+ as per the bindings,
+ Documentation/devicetree/bindings/mailbox/omap-mailbox.txt
+ This property should match with the sub-mailbox node used in
+ the firmware image.
+
+ clocks:
+ description: |
+ Main functional clock for the remote processor
+
+ resets:
+ description: |
+ Reset handles for the remote processor
+
+ memory-region:
+ $ref: /schemas/types.yaml#/definitions/phandle
+ description: |
+ phandle to the reserved memory node to be associated
+ with the remoteproc device. The reserved memory node
+ can be a CMA memory node, and should be defined as
+ per the bindings,
+ Documentation/devicetree/bindings/reserved-memory/reserved-memory.txt
+
+ firmware-name:
+ description: |
+ Default name of the firmware to load to the remote processor.
+
+# Optional properties:
+# --------------------
+# Some of these properties are mandatory on some SoCs, and some are optional
+# depending on the configuration of the firmware image to be executed on the
+# remote processor. The conditions are mentioned for each property.
+#
+# The following are the optional properties:
+
+ reg:
+ description: |
+ Address space for any remoteproc memories present on
+ the SoC. Should contain an entry for each value in
+ 'reg-names'. These are mandatory for all DSP and IPU
+ processors that have them (OMAP4/OMAP5 DSPs do not have
+ any RAMs)
+
+ reg-names:
+ description: |
+ Required names for each of the address spaces defined in
+ the 'reg' property. Expects the names from the following
+ list, in the specified order, each representing the corresponding
+ internal RAM memory region.
+ minItems: 1
+ maxItems: 3
+ items:
+ - const: l2ram
+ - const: l1pram
+ - const: l1dram
+
+ ti,bootreg:
+ $ref: /schemas/types.yaml#/definitions/phandle-array
+ description: |
+ Should be a triple of the phandle to the System Control
+ Configuration region that contains the boot address
+ register, the register offset of the boot address
+ register within the System Control module, and the bit
+ shift within the register. This property is required for
+ all the DSP instances on OMAP4, OMAP5 and DRA7xx SoCs.
+
+ ti,autosuspend-delay-ms:
+ description: |
+ Custom autosuspend delay for the remoteproc in milliseconds.
+
+ ti,timers:
+ $ref: /schemas/types.yaml#/definitions/phandle-array
+ description: |
+ One or more phandles to OMAP DMTimer nodes, that serve
+ as System/Tick timers for the OS running on the remote
+ processors. This will usually be a single timer if the
+ processor sub-system is running in SMP mode, or one per
+ core in the processor sub-system. This can also be used
+ to reserve specific timers to be dedicated to the
+ remote processors.
+
+ This property is mandatory on remote processors requiring
+ external tick wakeup, and to support Power Management
+ features. The timers to be used should match with the
+ timers used in the firmware image.
+
+ ti,watchdog-timers:
+ $ref: /schemas/types.yaml#/definitions/phandle-array
+ description: |
+ One or more phandles to OMAP DMTimer nodes, used to
+ serve as Watchdog timers for the processor cores. This
+ will usually be one per executing processor core, even
+ if the processor sub-system is running a SMP OS.
+
+ The timers to be used should match with the watchdog
+ timers used in the firmware image.
+
+if:
+ properties:
+ compatible:
+ enum:
+ - ti,dra7-dsp
+then:
+ properties:
+ reg:
+ minItems: 3
+ maxItems: 3
+ required:
+ - reg
+ - reg-names
+ - ti,bootreg
+
+else:
+ if:
+ properties:
+ compatible:
+ enum:
+ - ti,omap4-ipu
+ - ti,omap5-ipu
+ - ti,dra7-ipu
+ then:
+ properties:
+ reg:
+ minItems: 1
+ maxItems: 1
+ ti,bootreg: false
+ required:
+ - reg
+ - reg-names
+
+ else:
+ properties:
+ reg: false
+ required:
+ - ti,bootreg
+
+required:
+ - compatible
+ - iommus
+ - mboxes
+ - memory-region
+ - clocks
+ - resets
+ - firmware-name
+
+additionalProperties: false
+
+examples:
+ - |
+
+ //Example 1: OMAP4 DSP
+
+ /* DSP Reserved Memory node */
+ #include <dt-bindings/clock/omap4.h>
+ reserved-memory {
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ dsp_memory_region: dsp-memory@98000000 {
+ compatible = "shared-dma-pool";
+ reg = <0x98000000 0x800000>;
+ reusable;
+ };
+ };
+
+ /* DSP node */
+ ocp {
+ dsp: dsp {
+ compatible = "ti,omap4-dsp";
+ ti,bootreg = <&scm_conf 0x304 0>;
+ iommus = <&mmu_dsp>;
+ mboxes = <&mailbox &mbox_dsp>;
+ memory-region = <&dsp_memory_region>;
+ ti,timers = <&timer5>;
+ ti,watchdog-timers = <&timer6>;
+ clocks = <&tesla_clkctrl OMAP4_DSP_CLKCTRL 0>;
+ resets = <&prm_tesla 0>, <&prm_tesla 1>;
+ firmware-name = "omap4-dsp-fw.xe64T";
+ };
+ };
+
+ - |+
+
+ //Example 2: OMAP5 IPU
+
+ /* IPU Reserved Memory node */
+ #include <dt-bindings/clock/omap5.h>
+ reserved-memory {
+ #address-cells = <2>;
+ #size-cells = <2>;
+
+ ipu_memory_region: ipu-memory@95800000 {
+ compatible = "shared-dma-pool";
+ reg = <0 0x95800000 0 0x3800000>;
+ reusable;
+ };
+ };
+
+ /* IPU node */
+ ocp {
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ ipu: ipu@55020000 {
+ compatible = "ti,omap5-ipu";
+ reg = <0x55020000 0x10000>;
+ reg-names = "l2ram";
+ iommus = <&mmu_ipu>;
+ mboxes = <&mailbox &mbox_ipu>;
+ memory-region = <&ipu_memory_region>;
+ ti,timers = <&timer3>, <&timer4>;
+ ti,watchdog-timers = <&timer9>, <&timer11>;
+ clocks = <&ipu_clkctrl OMAP5_MMU_IPU_CLKCTRL 0>;
+ resets = <&prm_core 2>;
+ firmware-name = "omap5-ipu-fw.xem4";
+ };
+ };
+
+ - |+
+
+ //Example 3: DRA7xx/AM57xx DSP
+
+ /* DSP1 Reserved Memory node */
+ #include <dt-bindings/clock/dra7.h>
+ reserved-memory {
+ #address-cells = <2>;
+ #size-cells = <2>;
+
+ dsp1_memory_region: dsp1-memory@99000000 {
+ compatible = "shared-dma-pool";
+ reg = <0x0 0x99000000 0x0 0x4000000>;
+ reusable;
+ };
+ };
+
+ /* DSP1 node */
+ ocp {
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ dsp1: dsp@40800000 {
+ compatible = "ti,dra7-dsp";
+ reg = <0x40800000 0x48000>,
+ <0x40e00000 0x8000>,
+ <0x40f00000 0x8000>;
+ reg-names = "l2ram", "l1pram", "l1dram";
+ ti,bootreg = <&scm_conf 0x55c 0>;
+ iommus = <&mmu0_dsp1>, <&mmu1_dsp1>;
+ mboxes = <&mailbox5 &mbox_dsp1_ipc3x>;
+ memory-region = <&dsp1_memory_region>;
+ ti,timers = <&timer5>;
+ ti,watchdog-timers = <&timer10>;
+ resets = <&prm_dsp1 0>;
+ clocks = <&dsp1_clkctrl DRA7_DSP1_MMU0_DSP1_CLKCTRL 0>;
+ firmware-name = "dra7-dsp1-fw.xe66";
+ };
+ };
--
2.17.1
--
Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki. Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
^ permalink raw reply related [flat|nested] 2+ messages in thread