[PATCH net-next v3 3/3] dt-bindings: net: mdio: Make descriptions more general

[Florian Fainelli <f.fainelli@gmail.com>]

A number of descriptions assume a PHY device, but since this binding
describes a MDIO bus which can have different kinds of MDIO devices
attached to it, rephrase some descriptions to be more general in that
regard.

Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
---
 Documentation/devicetree/bindings/net/mdio.yaml | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/Documentation/devicetree/bindings/net/mdio.yaml b/Documentation/devicetree/bindings/net/mdio.yaml
index 9efb7d623f0e..d83fe5980fb8 100644
--- a/Documentation/devicetree/bindings/net/mdio.yaml
+++ b/Documentation/devicetree/bindings/net/mdio.yaml
@@ -31,13 +31,13 @@ properties:
     maxItems: 1
     description:
       The phandle and specifier for the GPIO that controls the RESET
-      lines of all PHYs on that MDIO bus.
+      lines of all devices on that MDIO bus.
 
   reset-delay-us:
     description:
-      RESET pulse width in microseconds. It applies to all PHY devices
-      and must therefore be appropriately determined based on all PHY
-      requirements (maximum value of all per-PHY RESET pulse widths).
+      RESET pulse width in microseconds. It applies to all MDIO devices
+      and must therefore be appropriately determined based on all devices
+      requirements (maximum value of all per-device RESET pulse widths).
 
 patternProperties:
   "^ethernet-phy@[0-9a-f]+$":
@@ -48,7 +48,7 @@ patternProperties:
         minimum: 0
         maximum: 31
         description:
-          The ID number for the PHY.
+          The ID number for the device.
 
       broken-turn-around:
         $ref: /schemas/types.yaml#definitions/flag
-- 
2.19.1