[PATCH 1/7] arm64: dts: qcom: pm8009: Add base dts file

[Dmitry Baryshkov <dmitry.baryshkov@linaro.org>]

Add base DTS file for pm8009 along with GPIOs and power-on nodes.

Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
---
 arch/arm64/boot/dts/qcom/pm8009.dtsi | 40 ++++++++++++++++++++++++++++
 1 file changed, 40 insertions(+)
 create mode 100644 arch/arm64/boot/dts/qcom/pm8009.dtsi

diff --git a/arch/arm64/boot/dts/qcom/pm8009.dtsi b/arch/arm64/boot/dts/qcom/pm8009.dtsi
new file mode 100644
index 000000000000..9f3e19b5bd00
--- /dev/null
+++ b/arch/arm64/boot/dts/qcom/pm8009.dtsi
@@ -0,0 +1,40 @@
+// SPDX-License-Identifier: BSD-3-Clause
+/*
+ * Copyright (c) 2017-2019, The Linux Foundation. All rights reserved.
+ * Copyright (c) 2019, Linaro Limited
+ */
+
+#include <dt-bindings/input/input.h>
+#include <dt-bindings/interrupt-controller/irq.h>
+#include <dt-bindings/spmi/spmi.h>
+#include <dt-bindings/iio/qcom,spmi-vadc.h>
+
+&spmi_bus {
+	pmic@a {
+		compatible = "qcom,pm8009", "qcom,spmi-pmic";
+		reg = <0xa SPMI_USID>;
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		power-on@800 {
+			compatible = "qcom,pm8916-pon";
+			reg = <0x0800>;
+		};
+
+		pm8009_gpios: gpio@c000 {
+			compatible = "qcom,pm8005-gpio";
+			reg = <0xc000>;
+			gpio-controller;
+			#gpio-cells = <2>;
+			interrupt-controller;
+			#interrupt-cells = <2>;
+		};
+	};
+
+	pmic@b {
+		compatible = "qcom,pm8009", "qcom,spmi-pmic";
+		reg = <0xb SPMI_USID>;
+		#address-cells = <1>;
+		#size-cells = <0>;
+	};
+};
-- 
2.26.2