* [PATCH v4 10/10] net: eth: altera: update devicetree bindings documentation
[not found] <20200708072401.169150-1-joyce.ooi@intel.com>
@ 2020-07-08 7:24 ` Ooi, Joyce
0 siblings, 0 replies; only message in thread
From: Ooi, Joyce @ 2020-07-08 7:24 UTC (permalink / raw)
To: Thor Thayer, David S . Miller, Jakub Kicinski
Cc: netdev, linux-kernel, Dalon Westergreen, Joyce Ooi, Tan Ley Foon,
See Chin Liang, Dinh Nguyen, Dalon Westergreen, Rob Herring,
devicetree
From: Dalon Westergreen <dalon.westergreen@intel.com>
Update devicetree bindings documentation to include msgdma
prefetcher and ptp bindings.
Cc: Rob Herring <robh+dt@kernel.org>
Cc: devicetree@vger.kernel.org
Signed-off-by: Dalon Westergreen <dalon.westergreen@intel.com>
Signed-off-by: Joyce Ooi <joyce.ooi@intel.com>
Reviewed-by: Rob Herring <robh@kernel.org>
---
v2: no change
v3: no change
v4: no change
---
.../devicetree/bindings/net/altera_tse.txt | 103 +++++++++++++++++----
1 file changed, 84 insertions(+), 19 deletions(-)
diff --git a/Documentation/devicetree/bindings/net/altera_tse.txt b/Documentation/devicetree/bindings/net/altera_tse.txt
index 0b7d4d3758ea..2f2d12603907 100644
--- a/Documentation/devicetree/bindings/net/altera_tse.txt
+++ b/Documentation/devicetree/bindings/net/altera_tse.txt
@@ -2,53 +2,86 @@
Required properties:
- compatible: Should be "altr,tse-1.0" for legacy SGDMA based TSE, and should
- be "altr,tse-msgdma-1.0" for the preferred MSGDMA based TSE.
+ be "altr,tse-msgdma-1.0" for the preferred MSGDMA based TSE,
+ and "altr,tse-msgdma-2.0" for MSGDMA with prefetcher based
+ implementations.
ALTR is supported for legacy device trees, but is deprecated.
altr should be used for all new designs.
- reg: Address and length of the register set for the device. It contains
the information of registers in the same order as described by reg-names
- reg-names: Should contain the reg names
- "control_port": MAC configuration space region
- "tx_csr": xDMA Tx dispatcher control and status space region
- "tx_desc": MSGDMA Tx dispatcher descriptor space region
- "rx_csr" : xDMA Rx dispatcher control and status space region
- "rx_desc": MSGDMA Rx dispatcher descriptor space region
- "rx_resp": MSGDMA Rx dispatcher response space region
- "s1": SGDMA descriptor memory
- interrupts: Should contain the TSE interrupts and it's mode.
- interrupt-names: Should contain the interrupt names
- "rx_irq": xDMA Rx dispatcher interrupt
- "tx_irq": xDMA Tx dispatcher interrupt
+ "rx_irq": DMA Rx dispatcher interrupt
+ "tx_irq": DMA Tx dispatcher interrupt
- rx-fifo-depth: MAC receive FIFO buffer depth in bytes
- tx-fifo-depth: MAC transmit FIFO buffer depth in bytes
- phy-mode: See ethernet.txt in the same directory.
- phy-handle: See ethernet.txt in the same directory.
- phy-addr: See ethernet.txt in the same directory. A configuration should
include phy-handle or phy-addr.
-- altr,has-supplementary-unicast:
- If present, TSE supports additional unicast addresses.
- Otherwise additional unicast addresses are not supported.
-- altr,has-hash-multicast-filter:
- If present, TSE supports a hash based multicast filter.
- Otherwise, hash-based multicast filtering is not supported.
-
- mdio device tree subnode: When the TSE has a phy connected to its local
mdio, there must be device tree subnode with the following
required properties:
-
- compatible: Must be "altr,tse-mdio".
- #address-cells: Must be <1>.
- #size-cells: Must be <0>.
For each phy on the mdio bus, there must be a node with the following
fields:
-
- reg: phy id used to communicate to phy.
- device_type: Must be "ethernet-phy".
The MAC address will be determined using the optional properties defined in
ethernet.txt.
+- altr,has-supplementary-unicast:
+ If present, TSE supports additional unicast addresses.
+ Otherwise additional unicast addresses are not supported.
+- altr,has-hash-multicast-filter:
+ If present, TSE supports a hash based multicast filter.
+ Otherwise, hash-based multicast filtering is not supported.
+- altr,has-ptp:
+ If present, TSE supports 1588 timestamping. Currently only
+ supported with the msgdma prefetcher.
+- altr,tx-poll-cnt:
+ Optional cycle count for Tx prefetcher to poll descriptor
+ list. If not present, defaults to 128, which at 125MHz is
+ roughly 1usec. Only for "altr,tse-msgdma-2.0".
+- altr,rx-poll-cnt:
+ Optional cycle count for Tx prefetcher to poll descriptor
+ list. If not present, defaults to 128, which at 125MHz is
+ roughly 1usec. Only for "altr,tse-msgdma-2.0".
+
+Required registers by compatibility string:
+ - "altr,tse-1.0"
+ "control_port": MAC configuration space region
+ "tx_csr": DMA Tx dispatcher control and status space region
+ "rx_csr" : DMA Rx dispatcher control and status space region
+ "s1": DMA descriptor memory
+
+ - "altr,tse-msgdma-1.0"
+ "control_port": MAC configuration space region
+ "tx_csr": DMA Tx dispatcher control and status space region
+ "tx_desc": DMA Tx dispatcher descriptor space region
+ "rx_csr" : DMA Rx dispatcher control and status space region
+ "rx_desc": DMA Rx dispatcher descriptor space region
+ "rx_resp": DMA Rx dispatcher response space region
+
+ - "altr,tse-msgdma-2.0"
+ "control_port": MAC configuration space region
+ "tx_csr": DMA Tx dispatcher control and status space region
+ "tx_pref": DMA Tx prefetcher configuration space region
+ "rx_csr" : DMA Rx dispatcher control and status space region
+ "rx_pref": DMA Rx prefetcher configuration space region
+ "tod_ctrl": Time of Day Control register only required when
+ timestamping support is enabled. Timestamping is
+ only supported with the msgdma-2.0 implementation.
+
+Optional properties:
+- local-mac-address: See ethernet.txt in the same directory.
+- max-frame-size: See ethernet.txt in the same directory.
+
Example:
tse_sub_0_eth_tse_0: ethernet@1,00000000 {
@@ -86,6 +119,11 @@ Example:
device_type = "ethernet-phy";
};
+ phy2: ethernet-phy@2 {
+ reg = <0x2>;
+ device_type = "ethernet-phy";
+ };
+
};
};
@@ -111,3 +149,30 @@ Example:
altr,has-hash-multicast-filter;
phy-handle = <&phy1>;
};
+
+
+ tse_sub_2_eth_tse_0: ethernet@1,00002000 {
+ compatible = "altr,tse-msgdma-2.0";
+ reg = <0x00000001 0x00002000 0x00000400>,
+ <0x00000001 0x00002400 0x00000020>,
+ <0x00000001 0x00002420 0x00000020>,
+ <0x00000001 0x00002440 0x00000020>,
+ <0x00000001 0x00002460 0x00000020>,
+ <0x00000001 0x00002480 0x00000040>;
+ reg-names = "control_port", "rx_csr", "rx_pref","tx_csr", "tx_pref", "tod_ctrl";
+ interrupt-parent = <&hps_0_arm_gic_0>;
+ interrupts = <0 45 4>, <0 44 4>;
+ interrupt-names = "rx_irq", "tx_irq";
+ rx-fifo-depth = <2048>;
+ tx-fifo-depth = <2048>;
+ address-bits = <48>;
+ max-frame-size = <1500>;
+ local-mac-address = [ 00 00 00 00 00 00 ];
+ phy-mode = "sgmii";
+ altr,has-supplementary-unicast;
+ altr,has-hash-multicast-filter;
+ altr,has-ptp;
+ altr,tx-poll-cnt = <128>;
+ altr,rx-poll-cnt = <32>;
+ phy-handle = <&phy2>;
+ };
--
2.13.0
^ permalink raw reply related [flat|nested] only message in thread