[PATCH 1/2] dt-bindings: interrupt-controller: add Hisilicon SD5203 vector interrupt controller

[Zhen Lei <thunder.leizhen@huawei.com>]

Add DT bindings for the Hisilicon SD5203 vector interrupt controller.

Signed-off-by: Zhen Lei <thunder.leizhen@huawei.com>
---
 .../hisilicon,sd5203-vic.txt                  | 27 +++++++++++++++++++
 1 file changed, 27 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/interrupt-controller/hisilicon,sd5203-vic.txt

diff --git a/Documentation/devicetree/bindings/interrupt-controller/hisilicon,sd5203-vic.txt b/Documentation/devicetree/bindings/interrupt-controller/hisilicon,sd5203-vic.txt
new file mode 100644
index 000000000000..a08292e868b0
--- /dev/null
+++ b/Documentation/devicetree/bindings/interrupt-controller/hisilicon,sd5203-vic.txt
@@ -0,0 +1,27 @@
+Hisilicon SD5203 vector interrupt controller (VIC)
+
+Hisilicon SD5203 VIC based on Synopsys DesignWare APB interrupt controller, but
+there's something special:
+1. The maximum number of irqs supported is 32. The registers ENABLE, MASK and
+   FINALSTATUS are 32 bits.
+2. There is only one VIC, it's used as primary interrupt controller.
+
+Required properties:
+- compatible: shall be "hisilicon,sd5203-vic"
+- reg: physical base address of the controller and length of memory mapped
+  region starting with ENABLE_LOW register
+- interrupt-controller: identifies the node as an interrupt controller
+- #interrupt-cells: number of cells to encode an interrupt-specifier, shall be 1
+
+The interrupt sources map to the corresponding bits in the interrupt
+registers, i.e.
+- 0 maps to bit 0 of low interrupts,
+- 1 maps to bit 1 of low interrupts,
+
+Example:
+	vic: interrupt-controller@10130000 {
+		compatible = "hisilicon,sd5203-vic";
+		reg = <0x10130000 0x1000>;
+		interrupt-controller;
+		#interrupt-cells = <1>;
+	};
-- 
2.26.0.106.g9fadedd