Re: [PATCH v2] dt-bindings: mfd: correct interrupt flags in examples

[Lee Jones <lee.jones@linaro.org>]

On Thu, 17 Sep 2020, Krzysztof Kozlowski wrote:

> GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
> These are simple defines so they could be used in DTS but they will not
> have the same meaning:
> 1. GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE
> 2. GPIO_ACTIVE_LOW  = 1 = IRQ_TYPE_EDGE_RISING
> 
> Correct the interrupt flags, assuming the author of the code wanted same
> logical behavior behind the name "ACTIVE_xxx", this is:
>   ACTIVE_LOW => IRQ_TYPE_LEVEL_LOW
> 
> Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
> Acked-by: Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com> # for BD70528
> Acked-by: Tim Harvey <tharvey@gateworks.com> # for gateworks-gsc.yaml
> Acked-by: Rob Herring <robh@kernel.org>
> 
> ---
> 
> Changes since v1:
> 1. Add acks
> ---
>  Documentation/devicetree/bindings/mfd/act8945a.txt          | 2 +-
>  Documentation/devicetree/bindings/mfd/gateworks-gsc.yaml    | 3 ++-
>  Documentation/devicetree/bindings/mfd/rohm,bd70528-pmic.txt | 2 +-
>  3 files changed, 4 insertions(+), 3 deletions(-)

Applied, thanks.

-- 
Lee Jones [李琼斯]
Senior Technical Lead - Developer Services
Linaro.org │ Open source software for Arm SoCs
Follow Linaro: Facebook | Twitter | Blog