[PATCH v2 1/3] arm64: dts: marvell: espressobin-ultra: fix SPI-NOR config

[PATCH v2 1/3] arm64: dts: marvell: espressobin-ultra: fix SPI-NOR config

[Robert Marko]

SPI config for the SPI-NOR is incorrect and completely breaking
reading/writing to the onboard SPI-NOR.

SPI-NOR is connected in the single(x1) IO mode and not in the quad
(x4) mode.
Also, there is no need to override the max frequency from the DTSI
as the mx25u3235f that is used supports 104Mhz.

Signed-off-by: Robert Marko <robert.marko@sartura.hr>
---
 arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts | 4 ----
 1 file changed, 4 deletions(-)

diff --git a/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts b/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
index c5eb3604dd5b..610ff6f385c7 100644
--- a/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
+++ b/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
@@ -71,10 +71,6 @@ &sdhci1 {
 
 &spi0 {
 	flash@0 {
-		spi-max-frequency = <108000000>;
-		spi-rx-bus-width = <4>;
-		spi-tx-bus-width = <4>;
-
 		partitions {
 			compatible = "fixed-partitions";
 			#address-cells = <1>;
-- 
2.31.1

[PATCH v2 2/3] arm64: dts: marvell: espressobin-ultra: add PHY and switch reset pins

[Robert Marko]

Both the Topaz switch and 88E1512 PHY have their reset and interrupts
connected to the SoC.

So, define the Topaz and 88E1512 reset pins in the DTS.

Defining the interrupt pins wont work as both the 88E1512 and the
Topaz switch uses active LOW IRQ signals but the A37xx GPIO controller
only supports edge triggers.
88E1512 would require special setup anyway as its INT pin is shared with
the LED2 and you first need to configure it as INT.

Signed-off-by: Robert Marko <robert.marko@sartura.hr>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
---
 arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts b/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
index 610ff6f385c7..7c786d218f1b 100644
--- a/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
+++ b/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
@@ -114,12 +114,16 @@ &usb3 {
 &mdio {
 	extphy: ethernet-phy@1 {
 		reg = <1>;
+
+		reset-gpios = <&gpionb 2 GPIO_ACTIVE_LOW>;
 	};
 };
 
 &switch0 {
 	reg = <3>;
 
+	reset-gpios = <&gpiosb 23 GPIO_ACTIVE_LOW>;
+
 	ports {
 		switch0port1: port@1 {
 			reg = <1>;
-- 
2.31.1

[PATCH v2 3/3] arm64: dts: marvell: espressobin-ultra: enable front USB3 port

[Robert Marko]

Espressobin Ultra has a front panel USB3.0 Type-A port which works
just fine so enable it.
I dont see a reason why it was disabled in the first place anyway.

Fixes: 3404fe15a60f ("arm64: dts: marvell: add DT for ESPRESSObin-Ultra")
Signed-off-by: Robert Marko <robert.marko@sartura.hr>
---
Changes in v2:
* Add Fixes tag
---
 arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts | 1 -
 1 file changed, 1 deletion(-)

diff --git a/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts b/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
index 7c786d218f1b..070725b81be5 100644
--- a/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
+++ b/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
@@ -108,7 +108,6 @@ rtc@51 {
 
 &usb3 {
 	usb-phy = <&usb3_phy>;
-	status = "disabled";
 };
 
 &mdio {
-- 
2.31.1

Re: [PATCH v2 1/3] arm64: dts: marvell: espressobin-ultra: fix SPI-NOR config

[Pali Rohár]

On Tuesday 28 September 2021 18:27:02 Robert Marko wrote:
> SPI config for the SPI-NOR is incorrect and completely breaking
> reading/writing to the onboard SPI-NOR.
> 
> SPI-NOR is connected in the single(x1) IO mode and not in the quad
> (x4) mode.
> Also, there is no need to override the max frequency from the DTSI
> as the mx25u3235f that is used supports 104Mhz.
> 
> Signed-off-by: Robert Marko <robert.marko@sartura.hr>

Fixes: 3404fe15a60f ("arm64: dts: marvell: add DT for ESPRESSObin-Ultra")

> ---
>  arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts | 4 ----
>  1 file changed, 4 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts b/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
> index c5eb3604dd5b..610ff6f385c7 100644
> --- a/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
> +++ b/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
> @@ -71,10 +71,6 @@ &sdhci1 {
>  
>  &spi0 {
>  	flash@0 {
> -		spi-max-frequency = <108000000>;
> -		spi-rx-bus-width = <4>;
> -		spi-tx-bus-width = <4>;
> -
>  		partitions {
>  			compatible = "fixed-partitions";
>  			#address-cells = <1>;
> -- 
> 2.31.1
>