[PATCH 3/6] firmware: xilinx: Add ZynqMP firmware ioctl enums for RPU configuration.

[Tanmay Shah <tanmay.shah@xilinx.com>]

From: Ben Levinsky <ben.levinsky@xilinx.com>

Add ZynqMP firmware ioctl enums for RPU configuration and TCM Nodes for
later use via request_node and release_node

Signed-off-by: Ben Levinsky <ben.levinsky@xilinx.com>
Signed-off-by: Tanmay Shah <tanmay.shah@xilinx.com>
---
 include/linux/firmware/xlnx-zynqmp.h | 19 +++++++++++++++++++
 1 file changed, 19 insertions(+)

diff --git a/include/linux/firmware/xlnx-zynqmp.h b/include/linux/firmware/xlnx-zynqmp.h
index 56b426fe020c..92bf3ae20524 100644
--- a/include/linux/firmware/xlnx-zynqmp.h
+++ b/include/linux/firmware/xlnx-zynqmp.h
@@ -111,6 +111,10 @@ enum pm_ret_status {
 };

 enum pm_ioctl_id {
+       IOCTL_GET_RPU_OPER_MODE = 0,
+       IOCTL_SET_RPU_OPER_MODE = 1,
+       IOCTL_RPU_BOOT_ADDR_CONFIG = 2,
+       IOCTL_TCM_COMB_CONFIG = 3,
        IOCTL_SD_DLL_RESET = 6,
        IOCTL_SET_SD_TAPDELAY = 7,
        IOCTL_SET_PLL_FRAC_MODE = 8,
@@ -142,6 +146,21 @@ enum pm_query_id {
        PM_QID_CLOCK_GET_MAX_DIVISOR = 13,
 };

+enum rpu_oper_mode {
+       PM_RPU_MODE_LOCKSTEP = 0,
+       PM_RPU_MODE_SPLIT = 1,
+};
+
+enum rpu_boot_mem {
+       PM_RPU_BOOTMEM_LOVEC = 0,
+       PM_RPU_BOOTMEM_HIVEC = 1,
+};
+
+enum rpu_tcm_comb {
+       PM_RPU_TCM_SPLIT = 0,
+       PM_RPU_TCM_COMB = 1,
+};
+
 enum zynqmp_pm_reset_action {
        PM_RESET_ACTION_RELEASE = 0,
        PM_RESET_ACTION_ASSERT = 1,
--
2.25.1

This email and any attachments are intended for the sole use of the named recipient(s) and contain(s) confidential information that may be proprietary, privileged or copyrighted under applicable law. If you are not the intended recipient, do not read, copy, or forward this email message or any attachments. Delete this email message and any attachments immediately.