[PATCH 4/7] arm64: dts: qcom: pm8350c: stop depending on thermal_zones label

[Dmitry Baryshkov <dmitry.baryshkov@linaro.org>]

Most of SoC device trees do not provide the thermal_zones label. Thus
stop depending on it and use the full path to the thermal zones nodes.

Fixes: 3795fe7d497b ("arm64: dts: qcom: pm8350c: Add temp-alarm support")
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
---
 arch/arm64/boot/dts/qcom/pm8350c.dtsi | 32 ++++++++++++++-------------
 1 file changed, 17 insertions(+), 15 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/pm8350c.dtsi b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
index e1b75ae0a823..9bc6464477bd 100644
--- a/arch/arm64/boot/dts/qcom/pm8350c.dtsi
+++ b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
@@ -32,23 +32,25 @@ pm8350c_gpios: gpio@8800 {
 	};
 };
 
-&thermal_zones {
-	pm8350c_thermal: pm8350c-thermal {
-		polling-delay-passive = <100>;
-		polling-delay = <0>;
-		thermal-sensors = <&pm8350c_temp_alarm>;
+/ {
+	thermal-zones {
+		pm8350c_thermal: pm8350c-thermal {
+			polling-delay-passive = <100>;
+			polling-delay = <0>;
+			thermal-sensors = <&pm8350c_temp_alarm>;
 
-		trips {
-			pm8350c_trip0: trip0 {
-				temperature = <95000>;
-				hysteresis = <0>;
-				type = "passive";
-			};
+			trips {
+				pm8350c_trip0: trip0 {
+					temperature = <95000>;
+					hysteresis = <0>;
+					type = "passive";
+				};
 
-			pm8350c_crit: pm8350c-crit {
-				temperature = <115000>;
-				hysteresis = <0>;
-				type = "critical";
+				pm8350c_crit: pm8350c-crit {
+					temperature = <115000>;
+					hysteresis = <0>;
+					type = "critical";
+				};
 			};
 		};
 	};
-- 
2.30.2