From: Conor Dooley <conor.dooley@microchip.com>
To: <mturquette@baylibre.com>, <sboyd@kernel.org>,
<aou@eecs.berkeley.edu>, <paul.walmsley@sifive.com>,
<palmer@rivosinc.com>, <a.zummo@towertech.it>,
<alexandre.belloni@bootlin.com>, <robh+dt@kernel.org>,
<krzk+dt@kernel.org>
Cc: <daire.mcnamara@microchip.com>, <linux-rtc@vger.kernel.org>,
<devicetree@vger.kernel.org>, <linux-clk@vger.kernel.org>,
<linux-riscv@lists.infradead.org>,
Conor Dooley <conor.dooley@microchip.com>
Subject: [PATCH v1 6/7] clk: microchip: mpfs: add RTCREF clock control
Date: Fri, 8 Apr 2022 14:36:46 +0000 [thread overview]
Message-ID: <20220408143646.3693104-7-conor.dooley@microchip.com> (raw)
In-Reply-To: <20220408143646.3693104-1-conor.dooley@microchip.com>
The reference clock used by the PolarFire SoC's onboard rtc was missing
from the clock driver. Add this clock at the "config" clock level, with
the external reference clock as its parent.
Reviewed-by: Daire McNamara <daire.mcnamara@microchip.com>
Signed-off-by: Conor Dooley <conor.dooley@microchip.com>
---
drivers/clk/microchip/clk-mpfs.c | 24 +++++++++++++++++++++++-
1 file changed, 23 insertions(+), 1 deletion(-)
diff --git a/drivers/clk/microchip/clk-mpfs.c b/drivers/clk/microchip/clk-mpfs.c
index f22d4b40ef28..4a506d0140d4 100644
--- a/drivers/clk/microchip/clk-mpfs.c
+++ b/drivers/clk/microchip/clk-mpfs.c
@@ -15,6 +15,7 @@
#define REG_MSSPLL_POSTDIV_CR 0x10u
#define REG_MSSPLL_SSCG_2_CR 0x2Cu
#define REG_CLOCK_CONFIG_CR 0x08u
+#define REG_RTC_CLOCK_CR 0x0Cu
#define REG_SUBBLK_CLOCK_CR 0x84u
#define MSSPLL_FBDIV_SHIFT 0x00u
@@ -95,6 +96,17 @@ static const struct clk_div_table mpfs_div_ahb_table[] = {
{ 0, 0 }
};
+/*
+ * The only two supported reference clock frequencies for the PolarFire SoC are
+ * 100 and 125 MHz, as the rtc reference is required to be 1 MHz.
+ * It therefore only needs to have divider table entries corresponding to
+ * divide by 100 and 125.
+ */
+static const struct clk_div_table mpfs_div_rtcref_table[] = {
+ { 100, 100 }, { 125, 125 },
+ { 0, 0 }
+};
+
static unsigned long mpfs_clk_msspll_recalc_rate(struct clk_hw *hw, unsigned long prate)
{
struct mpfs_msspll_hw_clock *msspll_hw = to_mpfs_msspll_clk(hw);
@@ -233,6 +245,16 @@ static struct mpfs_cfg_hw_clock mpfs_cfg_clks[] = {
REG_CLOCK_CONFIG_CR),
CLK_CFG(CLK_AHB, "clk_ahb", "clk_msspll", 4, 2, mpfs_div_ahb_table, 0,
REG_CLOCK_CONFIG_CR),
+ {
+ .cfg.id = CLK_RTCREF,
+ .cfg.shift = 0,
+ .cfg.width = 12,
+ .cfg.table = mpfs_div_rtcref_table,
+ .cfg.reg_offset = REG_RTC_CLOCK_CR,
+ .cfg.flags = CLK_DIVIDER_ONE_BASED,
+ .hw.init =
+ CLK_HW_INIT_PARENTS_DATA("clk_rtcref", mpfs_ext_ref, &mpfs_clk_cfg_ops, 0),
+ }
};
static int mpfs_clk_register_cfg(struct device *dev, struct mpfs_cfg_hw_clock *cfg_hw,
@@ -351,7 +373,7 @@ static struct mpfs_periph_hw_clock mpfs_periph_clks[] = {
CLK_PERIPH(CLK_MAC0, "clk_periph_mac0", PARENT_CLK(AHB), 1, 0),
CLK_PERIPH(CLK_MAC1, "clk_periph_mac1", PARENT_CLK(AHB), 2, 0),
CLK_PERIPH(CLK_MMC, "clk_periph_mmc", PARENT_CLK(AHB), 3, 0),
- CLK_PERIPH(CLK_TIMER, "clk_periph_timer", PARENT_CLK(AHB), 4, 0),
+ CLK_PERIPH(CLK_TIMER, "clk_periph_timer", PARENT_CLK(RTCREF), 4, 0),
CLK_PERIPH(CLK_MMUART0, "clk_periph_mmuart0", PARENT_CLK(AHB), 5, CLK_IS_CRITICAL),
CLK_PERIPH(CLK_MMUART1, "clk_periph_mmuart1", PARENT_CLK(AHB), 6, 0),
CLK_PERIPH(CLK_MMUART2, "clk_periph_mmuart2", PARENT_CLK(AHB), 7, 0),
--
2.35.1
next prev parent reply other threads:[~2022-04-08 14:38 UTC|newest]
Thread overview: 17+ messages / expand[flat|nested] mbox.gz Atom feed top
2022-04-08 14:36 [PATCH v1 0/7] Add rtc refclk support for PolarFire SoC Conor Dooley
2022-04-08 14:36 ` [PATCH v1 1/7] dt-bindings: clk: mpfs document msspll dri registers Conor Dooley
2022-04-08 14:54 ` Krzysztof Kozlowski
2022-04-08 14:36 ` [PATCH v1 2/7] dt-bindings: clk: mpfs: add defines for two new clocks Conor Dooley
2022-04-08 14:36 ` [PATCH v1 3/7] dt-bindings: rtc: add refclk to mpfs-rtc Conor Dooley
2022-04-08 14:56 ` Krzysztof Kozlowski
2022-04-08 14:36 ` [PATCH v1 4/7] clk: microchip: mpfs: re-parent the configurable clocks Conor Dooley
2022-04-08 14:36 ` [PATCH v1 5/7] clk: microchip: mpfs: rename sys_base to base Conor Dooley
2022-04-08 14:36 ` Conor Dooley [this message]
2022-04-08 14:36 ` [PATCH v1 7/7] riscv: dts: microchip: reparent mpfs clocks Conor Dooley
2022-04-08 14:57 ` [PATCH v1 0/7] Add rtc refclk support for PolarFire SoC Krzysztof Kozlowski
2022-04-08 15:29 ` Conor Dooley
2022-04-09 7:14 ` Conor Dooley
2022-04-09 10:48 ` Krzysztof Kozlowski
2022-04-09 20:17 ` Conor Dooley
2022-04-10 8:12 ` Krzysztof Kozlowski
2022-04-09 10:45 ` Krzysztof Kozlowski
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20220408143646.3693104-7-conor.dooley@microchip.com \
--to=conor.dooley@microchip.com \
--cc=a.zummo@towertech.it \
--cc=alexandre.belloni@bootlin.com \
--cc=aou@eecs.berkeley.edu \
--cc=daire.mcnamara@microchip.com \
--cc=devicetree@vger.kernel.org \
--cc=krzk+dt@kernel.org \
--cc=linux-clk@vger.kernel.org \
--cc=linux-riscv@lists.infradead.org \
--cc=linux-rtc@vger.kernel.org \
--cc=mturquette@baylibre.com \
--cc=palmer@rivosinc.com \
--cc=paul.walmsley@sifive.com \
--cc=robh+dt@kernel.org \
--cc=sboyd@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).