[PATCH 2/2] arm64: dts: imx8qm-mek: add usdhc pinctrl states to enable higher data rates

["Tamás Szűcs" <tszucs@protonmail.ch>]

Add pinctrl states 'state_100mhz' and 'state_200mhz' to usdhc1 and usdhc2 to
enable higher data rates for eMMC and SD.

Signed-off-by: Tamás Szűcs <tszucs@protonmail.ch>
---
 arch/arm64/boot/dts/freescale/imx8qm-mek.dts | 8 ++++++--
 1 file changed, 6 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8qm-mek.dts b/arch/arm64/boot/dts/freescale/imx8qm-mek.dts
index 19b60efe3639..5d4683173c30 100644
--- a/arch/arm64/boot/dts/freescale/imx8qm-mek.dts
+++ b/arch/arm64/boot/dts/freescale/imx8qm-mek.dts
@@ -68,8 +68,10 @@ ethphy1: ethernet-phy@1 {
 };

 &usdhc1 {
-	pinctrl-names = "default";
+	pinctrl-names = "default", "state_100mhz", "state_200mhz";
 	pinctrl-0 = <&pinctrl_usdhc1>;
+	pinctrl-1 = <&pinctrl_usdhc1>;
+	pinctrl-2 = <&pinctrl_usdhc1>;
 	bus-width = <8>;
 	no-sd;
 	no-sdio;
@@ -78,8 +80,10 @@ &usdhc1 {
 };

 &usdhc2 {
-	pinctrl-names = "default";
+	pinctrl-names = "default", "state_100mhz", "state_200mhz";
 	pinctrl-0 = <&pinctrl_usdhc2>, <&pinctrl_usdhc2_gpio>;
+	pinctrl-1 = <&pinctrl_usdhc2>, <&pinctrl_usdhc2_gpio>;
+	pinctrl-2 = <&pinctrl_usdhc2>, <&pinctrl_usdhc2_gpio>;
 	bus-width = <4>;
 	vmmc-supply = <&reg_usdhc2_vmmc>;
 	cd-gpios = <&lsio_gpio5 22 GPIO_ACTIVE_LOW>;
--
2.30.2