Re: [PATCH v2] dt-bindings: iio: gyroscope: bosch,bmg160: correct number of pins

[Jonathan Cameron <jic23@kernel.org>]

On Fri,  5 Aug 2022 09:55:03 +0200
Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> wrote:

> BMG160 has two interrupt pins to which interrupts can be freely mapped.
> Correct the schema to express such case and fix warnings like:
> 
>   qcom/msm8916-alcatel-idol347.dtb: gyroscope@68: interrupts: [[97, 1], [98, 1]] is too long
> 
> However the basic issue still persists - the interrupts should come in a
> defined order.
> 
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
> 
> ---
> 
> Changes since v1:
> 1. Accept also INT2 as one interrupt (Jonathan).

This doesn't work. If we are going to support either interrupt, at the very least
we need to require interrupt-names if the first one isn't INT1.  So your fix
is right but not enough.

Driver may ignore interrupt-names for now (would be good to have a sanity check in driver
though so the driver explicitly checks for INT2 and doesn't use the interrupt if
it is INT2 - support for that being for a future 'feature' addition).

A hacky solution would be to require the first one to always be INT1 but that
gives us no (backwards compatible) path forwards if someone does have a board
where only INT2 is wired.

So minimum change I think will be to provide interrupt-names allowing any of
INT1 (default if not specified)
INT1, INT2
INT2

and your fix below.

Thanks,

Jonathan



> ---
>  .../devicetree/bindings/iio/gyroscope/bosch,bmg160.yaml         | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/iio/gyroscope/bosch,bmg160.yaml b/Documentation/devicetree/bindings/iio/gyroscope/bosch,bmg160.yaml
> index b6bbc312a7cf..1414ba9977c1 100644
> --- a/Documentation/devicetree/bindings/iio/gyroscope/bosch,bmg160.yaml
> +++ b/Documentation/devicetree/bindings/iio/gyroscope/bosch,bmg160.yaml
> @@ -24,8 +24,10 @@ properties:
>  
>    interrupts:
>      minItems: 1
> +    maxItems: 2
>      description:
>        Should be configured with type IRQ_TYPE_EDGE_RISING.
> +      If two interrupts are provided, expected order is INT1 and INT2.
>  
>  required:
>    - compatible