[PATCH V2 net 1/2] dt-bindings: net: ar803x: add disable-hibernation-mode propetry

[wei.fang@nxp.com]

From: Wei Fang <wei.fang@nxp.com>

The hibernation mode of Atheros AR803x PHYs defaults to be
enabled after hardware reset. When the cable is unplugged,
the PHY will enter hibernation mode after about 10 seconds
and the PHY clocks will be stopped to save power.
However, some MACs need the phy output clock for proper
functioning of their logic. For instance, stmmac needs the
RX_CLK of PHY for software reset to complete.
Therefore, add a DT property to configure the PHY to disable
this hardware hibernation mode.

Signed-off-by: Wei Fang <wei.fang@nxp.com>
---
V2 change:
1. Add subject prefix.
2. Modify the property name and description to make them
clear.
---
 Documentation/devicetree/bindings/net/qca,ar803x.yaml | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/qca,ar803x.yaml b/Documentation/devicetree/bindings/net/qca,ar803x.yaml
index b3d4013b7ca6..9450cadad116 100644
--- a/Documentation/devicetree/bindings/net/qca,ar803x.yaml
+++ b/Documentation/devicetree/bindings/net/qca,ar803x.yaml
@@ -40,6 +40,13 @@ properties:
       Only supported on the AR8031.
     type: boolean
 
+  qca,disable-hibernation-mode:
+    description: |
+      Disable Atheros AR803X PHYs hibernation mode. If present, indicates
+      that the hardware of PHY will not enter power saving mode when the
+      cable is disconnected.
+    type: boolean
+
   qca,smarteee-tw-us-100m:
     description: EEE Tw parameter for 100M links.
     $ref: /schemas/types.yaml#/definitions/uint32
-- 
2.25.1