Re: [PATCH v4 0/8] arm64: dts: imx8mm-kontron: Improvements and OSM board support

[Shawn Guo <shawnguo@kernel.org>]

On Mon, Aug 22, 2022 at 10:03:46AM +0200, Frieder Schrempf wrote:
> From: Frieder Schrempf <frieder.schrempf@kontron.de>
> 
> This set contains a few improvements for the imx8mm-kontron devicetrees
> (patch 3-7) and support for a new SoM (patch 8, including baseboard) that
> complies to the Open Standard Module (OSM) 1.0 hardware specification, size S
> (https://sget.org/standards/osm).
> 
> It also includes binding changes in patch 1 and 2.
> 
> Changes in v4:
> * fix hex values and unit addresses in SPI NOR partition nodes
> * fix SoM dtsi includes
> 
> Changes in v3:
> * drop patch for 2 which was applied separately
> * rebase on v6.0-rc1
> * rename compatibles and file names
> 
> Changes in v2:
> * move binding changes to beginning of patchset
> * Allow arbitrary regulator names in PCA9450 bindings
> * Use voltage rail names from schematic for PMIC regulator-names
> * Add SPI NOR partition layout to devicetree
> * Remove unneeded header include
> * Add tags
> 
> Frieder Schrempf (8):
>   dt-bindings: arm: fsl: Rename compatibles for Kontron i.MX8MM
>     SoM/board
>   dt-bindings: arm: fsl: Add Kontron BL i.MX8MM OSM-S board
>   arm64: dts: imx8mm-kontron: Adjust compatibles, file names and model
>     strings
>   arm64: dts: imx8mm-kontron: Use the VSELECT signal to switch SD card
>     IO voltage
>   arm64: dts: imx8mm-kontron: Remove low DDRC operating point
>   arm64: dts: imx8mm-kontron: Use voltage rail names from schematic for
>     PMIC regulator-names
>   arm64: dts: imx8mm-kontron: Add SPI NOR partition layout
>   arm64: dts: Add support for Kontron SL/BL i.MX8MM OSM-S

Applied all, thanks!