[PATCH 10/23] ARM: dts: qcom: apq8064-cm-qs600: pull SDCC pwrseq node up one level

[Dmitry Baryshkov <dmitry.baryshkov@linaro.org>]

There are no need to add additional simple-bus nodes just to populate
a single pwrseq device. Pull it up one level into /. While we are at it
also fix node name replacing underscore with dash.

Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
---
 arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts | 17 +++++------------
 1 file changed, 5 insertions(+), 12 deletions(-)

diff --git a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
index 5ff0d9a275cc..d6ecfd8addb7 100644
--- a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
+++ b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
@@ -15,18 +15,11 @@ chosen {
 		stdout-path = "serial0:115200n8";
 	};
 
-	pwrseq {
-		#address-cells = <1>;
-		#size-cells = <1>;
-		ranges;
-		compatible = "simple-bus";
-
-		sdcc4_pwrseq: sdcc4_pwrseq {
-			pinctrl-names = "default";
-			pinctrl-0 = <&wlan_default_gpios>;
-			compatible = "mmc-pwrseq-simple";
-			reset-gpios = <&pm8921_gpio 43 GPIO_ACTIVE_LOW>;
-		};
+	sdcc4_pwrseq: pwrseq-sdcc4 {
+		pinctrl-names = "default";
+		pinctrl-0 = <&wlan_default_gpios>;
+		compatible = "mmc-pwrseq-simple";
+		reset-gpios = <&pm8921_gpio 43 GPIO_ACTIVE_LOW>;
 	};
 
 	/* on board fixed 3.3v supply */
-- 
2.35.1