[PATCH 05/23] ARM: dts: qcom: apq8064-ifc6410: pull SDCC pwrseq node up one level

[Dmitry Baryshkov <dmitry.baryshkov@linaro.org>]

There are no need to add additional simple-bus nodes just to populate
a single pwrseq device. Pull it up one level into /. While we are at it
also fix node name replacing underscore with dash.

Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
---
 arch/arm/boot/dts/qcom-apq8064-ifc6410.dts | 18 +++++++-----------
 1 file changed, 7 insertions(+), 11 deletions(-)

diff --git a/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts b/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts
index 610fb8d652c3..96307550523a 100644
--- a/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts
+++ b/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts
@@ -22,17 +22,6 @@ chosen {
 		stdout-path = "serial0:115200n8";
 	};
 
-	pwrseq {
-		compatible = "simple-bus";
-
-		sdcc4_pwrseq: sdcc4_pwrseq {
-			pinctrl-names = "default";
-			pinctrl-0 = <&wlan_default_gpios>;
-			compatible = "mmc-pwrseq-simple";
-			reset-gpios = <&pm8921_gpio 43 GPIO_ACTIVE_LOW>;
-		};
-	};
-
 	leds {
 		compatible = "gpio-leds";
 		pinctrl-names = "default";
@@ -57,6 +46,13 @@ hdmi_con: endpoint {
 		};
 	};
 
+	sdcc4_pwrseq: pwrseq-sdcc4 {
+		pinctrl-names = "default";
+		pinctrl-0 = <&wlan_default_gpios>;
+		compatible = "mmc-pwrseq-simple";
+		reset-gpios = <&pm8921_gpio 43 GPIO_ACTIVE_LOW>;
+	};
+
 	ext_3p3v: regulator-ext-3p3v {
 		compatible = "regulator-fixed";
 		regulator-min-microvolt = <3300000>;
-- 
2.35.1