[PATCH 0/3] leds: add driver for SPI driven WorldSemi WS2812B RGB LEDs

[Chuanhong Guo <gch981213@gmail.com>]

This patch adds support for driving a chain of WS2812B LED chips
using SPI bus.

WorldSemi WS2812B is a individually addressable LED chip that
can be chained together and controlled individually using a
single wire. The chip recognize a long pulse as a bit of 1 and
a short pulse as a bit of 0. Host sends a continuous stream
of 24-bits color values, each LED chip takes the first 3 byte
it receives as its color value and passes the leftover bytes to
the next LED on the chain.

This driver simulates this protocol using SPI bus by sending
a long pulse as 3'b110 and a short pulse as 3'b100. The SPI
frequency needs to be 2.105MHz~2.85MHz for the timing to be
correct and the controller needs to transfer all the bytes
continuously.

Chuanhong Guo (3):
  dt-bindings: vendor-prefixes: add an entry for WorldSemi
  dt-bindings: leds: add dt schema for worldsemi,ws2812b-spi
  leds: add driver for SPI driven WorldSemi WS2812B RGB LEDs

 .../bindings/leds/worldsemi,ws2812b-spi.yaml  | 131 +++++++++++
 .../devicetree/bindings/vendor-prefixes.yaml  |   2 +
 drivers/leds/rgb/Kconfig                      |  11 +
 drivers/leds/rgb/Makefile                     |   1 +
 drivers/leds/rgb/leds-ws2812b-spi.c           | 222 ++++++++++++++++++
 5 files changed, 367 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/leds/worldsemi,ws2812b-spi.yaml
 create mode 100644 drivers/leds/rgb/leds-ws2812b-spi.c

-- 
2.38.1