[PATCH] arm64: dts: rockchip: Change serial baud rate for Pinephone Pro to 1.5 MB

[Javier Martinez Canillas <javierm@redhat.com>]

This baud rate is set for the device by mainline u-boot and is also what
is set in the Pinebook Pro Device Tree, which is a device similar to the
PinePhone Pro but with a different form factor.

Otherwise, the baud rate of the firmware and Linux don't match by default
and a 'console=ttyS2,1500000n8' kernel command line parameter is required
to have proper output for both.

Signed-off-by: Javier Martinez Canillas <javierm@redhat.com>
---

I tried to instead get rid of the baud rate altogether, as suggested by
Peter Robinson. AFAIU that should just pick whatever bad rate has been
using by the early console.

But neither using 'stdout-path = "serial2" nor 'stdout-path = &uart2'
worked for me.

In both cases I didn't have any output unless setting a baud rate using
the 'console='param.

 arch/arm64/boot/dts/rockchip/rk3399-pinephone-pro.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/rockchip/rk3399-pinephone-pro.dts b/arch/arm64/boot/dts/rockchip/rk3399-pinephone-pro.dts
index a0795a2b1cb1..6bbe65bd5bd4 100644
--- a/arch/arm64/boot/dts/rockchip/rk3399-pinephone-pro.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3399-pinephone-pro.dts
@@ -26,7 +26,7 @@ aliases {
 	};
 
 	chosen {
-		stdout-path = "serial2:115200n8";
+		stdout-path = "serial2:1500000n8";
 	};
 
 	gpio-keys {

base-commit: 3adf89324a2b2a9dbc2c12d8895021e7e34e3346
-- 
2.40.0