From: Jai Luthra <j-luthra@ti.com>
To: Nishanth Menon <nm@ti.com>, Vignesh Raghavendra <vigneshr@ti.com>,
Tero Kristo <kristo@kernel.org>, Rob Herring <robh+dt@kernel.org>,
Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>,
Conor Dooley <conor+dt@kernel.org>
Cc: <linux-arm-kernel@lists.infradead.org>,
<devicetree@vger.kernel.org>, <linux-kernel@vger.kernel.org>,
Esteban Blanc <eblanc@baylibre.com>, <jneanne@baylibre.com>,
<aseketeli@baylibre.com>, <jpanis@baylibre.com>,
<u-kumar1@ti.com>, <j-luthra@ti.com>
Subject: [PATCH v5 0/6] Add TPS6594 PMIC support on several boards
Date: Wed, 9 Aug 2023 20:17:01 +0530 [thread overview]
Message-ID: <20230809-tps6594-v5-0-485fd3d63670@ti.com> (raw)
TPS6594 is a Power Management IC which provides regulators and others
features like GPIOs, RTC, watchdog, ESMs (Error Signal Monitor), and
PFSM (Pre-configurable Finite State Machine). The SoC and the PMIC can
communicate through the I2C or SPI interfaces.
TPS6594 is the super-set device while TPS6593 and LP8764 are derivatives.
This serie adds device tree nodes for TI TPS6594 PMICs found in the
following boards:
- J721EXSOMXEVM:
Link: https://www.ti.com/tool/J721EXSOMXEVM
- J721S2XSOMXEVM:
Link: https://www.ti.com/tool/J721S2XSOMXEVM
- J7200XSOMXEVM:
Link: https://www.ti.com/tool/J7200XSOMXEVM
- AM62A-SKEVM:
Link: https://www.ti.com/tool/SK-AM62A-LP
- J784S4XEVM
Link: https://www.ti.com/tool/J784S4XEVM
Changes from v4:
https://lore.kernel.org/all/20230727130908.10656-1-eblanc@baylibre.com/
- Range-diff: https://0x0.st/H_L7.diff
- Rebased on top of linux-next
- Fix min voltage on vdd_usb_3v3 regulator (ldo2) on j721e-som
- Use 3-hex-digit format for pinctrl values
Changes from v3:
https://lore.kernel.org/all/20230417154832.216774-1-eblanc@baylibre.com/
- Rebased on top of v6.5-rc1.
- Change pinctrl number for irq pin as wkup_pmx0 was split on some boards.
- Use already present wkup_i2c0 node instead of creating a new one.
Changes from v2:
https://lore.kernel.org/lkml/20230414112843.1358067-1-eblanc@baylibre.com/
- Change node name as per Krzysztof review.
- Add a fix for the interrupt range of wakeup gpio used by TPS6594 pmic
on J784S4.
The interruptions of the PMIC were not working before that.
- Remove dependencies on other patch series as that was a mistake, see
https://lore.kernel.org/lkml/CRYY2V3HJ0CP.96JQ18PLZB3C@burritosblues/
Changes from v1:
https://lore.kernel.org/lkml/20230329142948.833800-1-eblanc@baylibre.com/
- Harmonize regulators names across the different boards.
- Adjust AVS voltage range.
- Remove some outdated comments.
- Add PMIC to J784S4 board.
- Compatible string modified to match dt-bindings.
- Add gpio-controller and gpio-cells properties.
---
Apelete Seketeli (1):
arm64: dts: ti: k3-j784s4-evm: Fix interrupt ranges for TPS6594 PMIC
Esteban Blanc (2):
arm64: dts: ti: k3-j7200-som-p0: Add TP6594 family PMICs
arm64: dts: ti: k3-j721s2-som-p0: Add TP6594 family PMICs
Jerome Neanne (2):
arm64: dts: ti: k3-j721e-som-p0: Add TP6594 family PMICs
arm64: dts: ti: k3-j784s4-evm: Add support for TPS6594 PMIC
Julien Panis (1):
arm64: dts: ti: k3-am62a7-sk: Add support for TPS6593 PMIC
arch/arm64/boot/dts/ti/k3-am62a7-sk.dts | 95 +++++++++++
arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi | 157 ++++++++++++++++++
arch/arm64/boot/dts/ti/k3-j721e-som-p0.dtsi | 163 +++++++++++++++++++
arch/arm64/boot/dts/ti/k3-j721s2-som-p0.dtsi | 199 +++++++++++++++++++++++
arch/arm64/boot/dts/ti/k3-j784s4-evm.dts | 104 ++++++++++++
arch/arm64/boot/dts/ti/k3-j784s4-mcu-wakeup.dtsi | 2 +-
6 files changed, 719 insertions(+), 1 deletion(-)
---
base-commit: 21ef7b1e17d039053edaeaf41142423810572741
change-id: 20230809-tps6594-e450b5738e66
Best regards,
--
Jai Luthra <j-luthra@ti.com>
next reply other threads:[~2023-08-09 14:48 UTC|newest]
Thread overview: 10+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-08-09 14:47 Jai Luthra [this message]
2023-08-09 14:47 ` [PATCH v5 1/6] arm64: dts: ti: k3-j7200-som-p0: Add TP6594 family PMICs Jai Luthra
2023-08-09 16:19 ` Nishanth Menon
2023-08-09 14:47 ` [PATCH v5 2/6] arm64: dts: ti: k3-j721s2-som-p0: " Jai Luthra
2023-08-09 14:47 ` [PATCH v5 3/6] arm64: dts: ti: k3-j721e-som-p0: " Jai Luthra
2023-08-09 14:47 ` [PATCH v5 4/6] arm64: dts: ti: k3-j784s4-evm: Fix interrupt ranges for TPS6594 PMIC Jai Luthra
2023-08-09 15:27 ` Nishanth Menon
2023-08-09 14:47 ` [PATCH v5 5/6] arm64: dts: ti: k3-j784s4-evm: Add support " Jai Luthra
2023-08-09 14:47 ` [PATCH v5 6/6] arm64: dts: ti: k3-am62a7-sk: Add support for TPS6593 PMIC Jai Luthra
2023-08-09 15:34 ` [PATCH v5 0/6] Add TPS6594 PMIC support on several boards Nishanth Menon
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20230809-tps6594-v5-0-485fd3d63670@ti.com \
--to=j-luthra@ti.com \
--cc=aseketeli@baylibre.com \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=eblanc@baylibre.com \
--cc=jneanne@baylibre.com \
--cc=jpanis@baylibre.com \
--cc=kristo@kernel.org \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=nm@ti.com \
--cc=robh+dt@kernel.org \
--cc=u-kumar1@ti.com \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).