[PATCH v3 6/9] arm64: dts: qcom: sa8775p-ride: add the second SGMII PHY

[Bartosz Golaszewski <brgl@bgdev.pl>]

From: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>

Add a second SGMII PHY that will be used by EMAC1 on sa8775p-ride.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>
---
 arch/arm64/boot/dts/qcom/sa8775p-ride.dts | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sa8775p-ride.dts b/arch/arm64/boot/dts/qcom/sa8775p-ride.dts
index f9e1a017798e..486cb48ecb9d 100644
--- a/arch/arm64/boot/dts/qcom/sa8775p-ride.dts
+++ b/arch/arm64/boot/dts/qcom/sa8775p-ride.dts
@@ -287,6 +287,15 @@ sgmii_phy0: phy@8 {
 			reset-assert-us = <11000>;
 			reset-deassert-us = <70000>;
 		};
+
+		sgmii_phy1: phy@a {
+			compatible = "ethernet-phy-id0141.0dd4";
+			reg = <0xa>;
+			device_type = "ethernet-phy";
+			reset-gpios = <&pmm8654au_2_gpios 9 GPIO_ACTIVE_LOW>;
+			reset-assert-us = <11000>;
+			reset-deassert-us = <70000>;
+		};
 	};
 
 	mtl_rx_setup: rx-queues-config {
-- 
2.39.2