Re: [RFC PATCH net-next 1/2] dt-bindings: net: Add documentation for Half duplex support.

[Rob Herring <robh@kernel.org>]

On Wed, Aug 30, 2023 at 05:01:33PM +0530, MD Danish Anwar wrote:
> In order to support half-duplex operation at 10M and 100M link speeds, the
> PHY collision detection signal (COL) should be routed to ICSSG
> GPIO pin (PRGx_PRU0/1_GPI10) so that firmware can detect collision signal
> and apply the CSMA/CD algorithm applicable for half duplex operation. A DT
> property, "ti,half-duplex-capable" is introduced for this purpose. If
> board has PHY COL pin conencted to PRGx_PRU1_GPIO10, this DT property can
> be added to eth node of ICSSG, MII port to support half duplex operation at
> that port.

I take it the GPIO here is not visble to the OS and that's why it's not 
described in DT?
 
> 
> Signed-off-by: MD Danish Anwar <danishanwar@ti.com>
> ---
>  Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml | 7 +++++++
>  1 file changed, 7 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml b/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml
> index 13371159515a..59da9aeaee7e 100644
> --- a/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml
> +++ b/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml
> @@ -107,6 +107,13 @@ properties:
>                phandle to system controller node and register offset
>                to ICSSG control register for RGMII transmit delay
>  
> +          ti,half-duplex-capable:

capable or...

> +            type: boolean
> +            description:
> +              Enable half duplex operation on ICSSG MII port. This requires

enable the mode?

Maybe too late if it's already been assumed not supported, but shouldn't 
supporting half duplex be the default? I guess half duplex isn't too 
common any more.

Rob