[RFC PATCH net-next 5/6] microchip: lan865x: add driver support for Microchip's LAN865X MACPHY

[David Wretman <david.wretman@ferroamp.se>]

---
On Fri, Sep 08, 2023 at 07:59:18PM +0530, Parthiban Veerasooran wrote:
> The LAN8650/1 is designed to conform to the OPEN Alliance 10BASE‑T1x
> MAC‑PHY Serial Interface specification, Version 1.1. The IEEE Clause 4
> MAC integration provides the low pin count standard SPI interface to any
> microcontroller therefore providing Ethernet functionality without
> requiring MAC integration within the microcontroller. The LAN8650/1
> operates as an SPI client supporting SCLK clock rates up to a maximum of
> 25 MHz. This SPI interface supports the transfer of both data (Ethernet
> frames) and control (register access).
> 
> By default, the chunk data payload is 64 bytes in size. A smaller payload
> data size of 32 bytes is also supported and may be configured in the
> Chunk Payload Size (CPS) field of the Configuration 0 (OA_CONFIG0)
> register. Changing the chunk payload size requires the LAN8650/1 be reset
> and shall not be done during normal operation.
> 
> The Ethernet Media Access Controller (MAC) module implements a 10 Mbps
> half duplex Ethernet MAC, compatible with the IEEE 802.3 standard.
> 10BASE-T1S physical layer transceiver integrated into the LAN8650/1. The
> PHY and MAC are connected via an internal Media Independent Interface
> (MII).
> 
> Signed-off-by: Parthiban Veerasooran <Parthiban.Veerasooran@microchip.com>

Hi Parthiban,

Thanks for these patches.

One thing I am missing is settings for PLCA parameters. I feel that the
driver is a bit lacking as long as this is missing.

Adding support for the ethtool plca options would make this much more
complete.

Regards,
David