devicetree.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Christophe Roullier <christophe.roullier@foss.st.com>
To: "David S . Miller" <davem@davemloft.net>,
	Eric Dumazet <edumazet@google.com>,
	Jakub Kicinski <kuba@kernel.org>, Paolo Abeni <pabeni@redhat.com>,
	Rob Herring <robh+dt@kernel.org>,
	Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>,
	Conor Dooley <conor+dt@kernel.org>,
	Maxime Coquelin <mcoquelin.stm32@gmail.com>,
	Alexandre Torgue <alexandre.torgue@foss.st.com>,
	Richard Cochran <richardcochran@gmail.com>,
	Jose Abreu <joabreu@synopsys.com>,
	Liam Girdwood <lgirdwood@gmail.com>,
	Mark Brown <broonie@kernel.org>,
	Christophe Roullier <christophe.roullier@foss.st.com>,
	Marek Vasut <marex@denx.de>
Cc: <netdev@vger.kernel.org>, <devicetree@vger.kernel.org>,
	<linux-stm32@st-md-mailman.stormreply.com>,
	<linux-arm-kernel@lists.infradead.org>,
	<linux-kernel@vger.kernel.org>
Subject: [net-next,PATCH v7 8/8] net: stmmac: dwmac-stm32: add management of stm32mp13 for stm32
Date: Tue, 11 Jun 2024 10:36:06 +0200	[thread overview]
Message-ID: <20240611083606.733453-9-christophe.roullier@foss.st.com> (raw)
In-Reply-To: <20240611083606.733453-1-christophe.roullier@foss.st.com>

Add Ethernet support for STM32MP13.
STM32MP13 is STM32 SOC with 2 GMACs instances.
GMAC IP version is SNPS 4.20.
GMAC IP configure with 1 RX and 1 TX queue.
DMA HW capability register supported
RX Checksum Offload Engine supported
TX Checksum insertion supported
Wake-Up On Lan supported
TSO supported

Signed-off-by: Christophe Roullier <christophe.roullier@foss.st.com>
---
 .../net/ethernet/stmicro/stmmac/dwmac-stm32.c | 32 ++++++++++++++++---
 1 file changed, 28 insertions(+), 4 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c
index 09ff0be0bdcdc..b2db0e26c4e45 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c
@@ -104,6 +104,7 @@ struct stm32_ops {
 	int (*parse_data)(struct stm32_dwmac *dwmac,
 			  struct device *dev);
 	bool clk_rx_enable_in_suspend;
+	bool is_mp13;
 	u32 syscfg_clr_off;
 };
 
@@ -224,11 +225,18 @@ static int stm32mp1_configure_pmcr(struct plat_stmmacenet_data *plat_dat)
 {
 	struct stm32_dwmac *dwmac = plat_dat->bsp_priv;
 	u32 reg = dwmac->mode_reg;
-	int val;
+	int val = 0;
 
 	switch (plat_dat->mac_interface) {
 	case PHY_INTERFACE_MODE_MII:
-		val = SYSCFG_PMCR_ETH_SEL_MII;
+		/*
+		 * STM32MP15xx supports both MII and GMII, STM32MP13xx MII only.
+		 * SYSCFG_PMCSETR ETH_SELMII is present only on STM32MP15xx and
+		 * acts as a selector between 0:GMII and 1:MII. As STM32MP13xx
+		 * supports only MII, ETH_SELMII is not present.
+		 */
+		if (!dwmac->ops->is_mp13)  /* Select MII mode on STM32MP15xx */
+			val |= SYSCFG_PMCR_ETH_SEL_MII;
 		break;
 	case PHY_INTERFACE_MODE_GMII:
 		val = SYSCFG_PMCR_ETH_SEL_GMII;
@@ -359,8 +367,12 @@ static int stm32_dwmac_parse_data(struct stm32_dwmac *dwmac,
 
 	dwmac->mode_mask = SYSCFG_MP1_ETH_MASK;
 	err = of_property_read_u32_index(np, "st,syscon", 2, &dwmac->mode_mask);
-	if (err)
-		dev_dbg(dev, "Warning sysconfig register mask not set\n");
+	if (err) {
+		if (dwmac->ops->is_mp13)
+			dev_err(dev, "Sysconfig register mask must be set (%d)\n", err);
+		else
+			dev_dbg(dev, "Warning sysconfig register mask not set\n");
+	}
 
 	return err;
 }
@@ -560,12 +572,24 @@ static struct stm32_ops stm32mp1_dwmac_data = {
 	.resume = stm32mp1_resume,
 	.parse_data = stm32mp1_parse_data,
 	.syscfg_clr_off = 0x44,
+	.is_mp13 = false,
+	.clk_rx_enable_in_suspend = true
+};
+
+static struct stm32_ops stm32mp13_dwmac_data = {
+	.set_mode = stm32mp1_set_mode,
+	.suspend = stm32mp1_suspend,
+	.resume = stm32mp1_resume,
+	.parse_data = stm32mp1_parse_data,
+	.syscfg_clr_off = 0x08,
+	.is_mp13 = true,
 	.clk_rx_enable_in_suspend = true
 };
 
 static const struct of_device_id stm32_dwmac_match[] = {
 	{ .compatible = "st,stm32-dwmac", .data = &stm32mcu_dwmac_data},
 	{ .compatible = "st,stm32mp1-dwmac", .data = &stm32mp1_dwmac_data},
+	{ .compatible = "st,stm32mp13-dwmac", .data = &stm32mp13_dwmac_data},
 	{ }
 };
 MODULE_DEVICE_TABLE(of, stm32_dwmac_match);
-- 
2.25.1


  parent reply	other threads:[~2024-06-11  8:39 UTC|newest]

Thread overview: 18+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2024-06-11  8:35 [net-next,PATCH v7 0/8] Series to deliver Ethernet for STM32MP13 Christophe Roullier
2024-06-11  8:35 ` [net-next,PATCH v7 1/8] dt-bindings: net: add STM32MP13 compatible in documentation for stm32 Christophe Roullier
2024-06-11  8:36 ` [net-next,PATCH v7 2/8] net: stmmac: dwmac-stm32: Separate out external clock rate validation Christophe Roullier
2024-06-26 10:38   ` Mark Brown
2024-06-27  6:45     ` Christophe ROULLIER
2024-06-11  8:36 ` [net-next,PATCH v7 3/8] net: stmmac: dwmac-stm32: Separate out external clock selector Christophe Roullier
2024-06-11  8:36 ` [net-next,PATCH v7 4/8] net: stmmac: dwmac-stm32: Extract PMCR configuration Christophe Roullier
2024-06-11  8:36 ` [net-next,PATCH v7 5/8] net: stmmac: dwmac-stm32: Clean up the debug prints Christophe Roullier
2024-06-11  8:36 ` [net-next,PATCH v7 6/8] net: stmmac: dwmac-stm32: Fix Mhz to MHz Christophe Roullier
2024-06-11  8:36 ` [net-next,PATCH v7 7/8] net: stmmac: dwmac-stm32: Mask support for PMCR configuration Christophe Roullier
2024-06-11 13:07   ` Marek Vasut
2024-06-11 13:32     ` Christophe ROULLIER
2024-06-11 16:16       ` Marek Vasut
2024-06-12  6:07         ` Christophe ROULLIER
2024-06-12  9:08   ` Marek Vasut
2024-06-11  8:36 ` Christophe Roullier [this message]
2024-06-12  9:09   ` [net-next,PATCH v7 8/8] net: stmmac: dwmac-stm32: add management of stm32mp13 for stm32 Marek Vasut
2024-06-14  9:00 ` [net-next,PATCH v7 0/8] Series to deliver Ethernet for STM32MP13 patchwork-bot+netdevbpf

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20240611083606.733453-9-christophe.roullier@foss.st.com \
    --to=christophe.roullier@foss.st.com \
    --cc=alexandre.torgue@foss.st.com \
    --cc=broonie@kernel.org \
    --cc=conor+dt@kernel.org \
    --cc=davem@davemloft.net \
    --cc=devicetree@vger.kernel.org \
    --cc=edumazet@google.com \
    --cc=joabreu@synopsys.com \
    --cc=krzysztof.kozlowski+dt@linaro.org \
    --cc=kuba@kernel.org \
    --cc=lgirdwood@gmail.com \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-stm32@st-md-mailman.stormreply.com \
    --cc=marex@denx.de \
    --cc=mcoquelin.stm32@gmail.com \
    --cc=netdev@vger.kernel.org \
    --cc=pabeni@redhat.com \
    --cc=richardcochran@gmail.com \
    --cc=robh+dt@kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).