Re: [PATCH v3 2/7] iio: pressure: bmp280: Add support for bmp280 soft reset

[Vasileios Amoiridis <vassilisamir@gmail.com>]

On Fri, Aug 23, 2024 at 10:13:57PM +0300, Andy Shevchenko wrote:
> On Fri, Aug 23, 2024 at 08:17:09PM +0200, Vasileios Amoiridis wrote:
> > The BM(P/E)28x devices have an option for soft reset which is also
> > recommended by the Bosch Sensortech BME2 Sensor API to be used before the
> > initial configuration of the device.
> 
> ...
> 
> > +static int bmp280_preinit(struct bmp280_data *data)
> > +{
> > +	unsigned int reg;
> > +	int ret;
> > +
> > +	ret = regmap_write(data->regmap, BMP280_REG_RESET, BMP280_RST_SOFT_CMD);
> > +	if (ret)
> > +		return dev_err_probe(data->dev, ret,
> > +				     "Failed to reset device.\n");
> 
> > +	usleep_range(data->start_up_time, data->start_up_time + 500);
> 
> Seems long enough to warrant the comment. Also, why not fsleep()?

Hi Andy,

The datasheet of the sensor, and the published API from Bosch [1] 
require the startup_time for this procedure, it's not something that
came up from my mind. That's why I didn't add any comment.

I was not aware of fsleep(), I think that it could be fine to use it.

Cheers,
Vasilis

[1]: https://github.com/boschsensortec/BME280_SensorAPI/blob/master/bme280.c#L677

> 
> > +	ret = regmap_read(data->regmap, BMP280_REG_STATUS, &reg);
> > +	if (ret)
> > +		return dev_err_probe(data->dev, ret,
> > +				     "Failed to read status register.\n");
> > +
> > +	if (reg & BMP280_REG_STATUS_IM_UPDATE)
> > +		return dev_err_probe(data->dev, ret,
> > +				     "Failed to copy NVM contents.\n");
> > +
> > +	return 0;
> > +}
> 
> 
> -- 
> With Best Regards,
> Andy Shevchenko
> 
>