From: Vasileios Amoiridis <vassilisamir@gmail.com>
To: Krzysztof Kozlowski <krzk@kernel.org>
Cc: Vasileios Amoiridis <vassilisamir@gmail.com>,
jic23@kernel.org, lars@metafoo.de, robh@kernel.org,
krzk+dt@kernel.org, conor+dt@kernel.org,
andriy.shevchenko@linux.intel.com, ang.iglesiasg@gmail.com,
linus.walleij@linaro.org, biju.das.jz@bp.renesas.com,
javier.carrasco.cruz@gmail.com, semen.protsenko@linaro.org,
579lpy@gmail.com, ak@it-klinger.de, linux-iio@vger.kernel.org,
devicetree@vger.kernel.org, linux-kernel@vger.kernel.org,
christophe.jaillet@wanadoo.fr
Subject: Re: [PATCH v5 5/7] dt-bindings: iio: pressure: bmp085: Add interrupts for BMP3xx and BMP5xx devices
Date: Wed, 4 Sep 2024 12:32:23 +0200 [thread overview]
Message-ID: <20240904103223.GE44250@vamoiridPC> (raw)
In-Reply-To: <mdxfwawym2tn3afsbq4jmygfkdokpleb7p2deomraqwjc6k5qu@laj4j3fw7k2x>
On Tue, Sep 03, 2024 at 08:34:22AM +0200, Krzysztof Kozlowski wrote:
> On Mon, Sep 02, 2024 at 08:42:20PM +0200, Vasileios Amoiridis wrote:
> > Add interrupt options for BMP3xx and BMP5xx devices as well.
> >
> > Signed-off-by: Vasileios Amoiridis <vassilisamir@gmail.com>
> > ---
> > .../bindings/iio/pressure/bmp085.yaml | 22 ++++++++++++++++++-
> > 1 file changed, 21 insertions(+), 1 deletion(-)
> >
> > diff --git a/Documentation/devicetree/bindings/iio/pressure/bmp085.yaml b/Documentation/devicetree/bindings/iio/pressure/bmp085.yaml
> > index 6fda887ee9d4..20b75865e02f 100644
> > --- a/Documentation/devicetree/bindings/iio/pressure/bmp085.yaml
> > +++ b/Documentation/devicetree/bindings/iio/pressure/bmp085.yaml
> > @@ -48,14 +48,34 @@ properties:
> >
> > interrupts:
> > description:
> > - interrupt mapping for IRQ (BMP085 only)
> > + interrupt mapping for IRQ. Supported in BMP085, BMP3xx, BMP5xx
> > maxItems: 1
> >
> > + drive-open-drain:
> > + description:
> > + set if the interrupt pin should be configured as open drain.
> > + If not set, defaults to push-pull configuration.
> > + type: boolean
> > +
> > +
>
> Just one blank liine.
>
Hi Krzysztof,
Thanks for the review. I can change that.
> > required:
> > - compatible
> > - vddd-supply
> > - vdda-supply
> >
> > +allOf:
> > + - if:
> > + properties:
> > + compatible:
> > + not:
> > + enum:
> > + - bosch,bmp085
> > + - bosch,bmp380
> > + - bosch,bmp580
>
> Are you sure you tested this patch?
>
Well, before I run only make dt_binding_check but with the option
make dtbs_check I now found what you meant. I think I miss a
"contains" here. In any case, make dtbs_check showed some other
warnings as well which I will address in a follow-up series.
> Best regards,
> Krzysztof
>
Cheers,
Vasilis
next prev parent reply other threads:[~2024-09-04 10:32 UTC|newest]
Thread overview: 23+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-09-02 18:42 [PATCH v5 0/7] pressure: bmp280: Minor cleanup and interrupt support Vasileios Amoiridis
2024-09-02 18:42 ` [PATCH v5 1/7] iio: pressure: bmp280: Use bulk read for humidity calibration data Vasileios Amoiridis
2024-09-02 18:42 ` [PATCH v5 2/7] iio: pressure: bmp280: Add support for bmp280 soft reset Vasileios Amoiridis
2024-09-02 18:42 ` [PATCH v5 3/7] iio: pressure: bmp280: Remove config error check for IIR filter updates Vasileios Amoiridis
2024-09-02 18:42 ` [PATCH v5 4/7] iio: pressure: bmp280: Use sleep and forced mode for oneshot captures Vasileios Amoiridis
2024-09-03 14:26 ` Andy Shevchenko
2024-09-04 10:24 ` Vasileios Amoiridis
2024-09-04 14:17 ` Andy Shevchenko
2024-09-04 14:21 ` Andy Shevchenko
2024-09-02 18:42 ` [PATCH v5 5/7] dt-bindings: iio: pressure: bmp085: Add interrupts for BMP3xx and BMP5xx devices Vasileios Amoiridis
2024-09-03 6:34 ` Krzysztof Kozlowski
2024-09-04 10:32 ` Vasileios Amoiridis [this message]
2024-09-02 18:42 ` [PATCH v5 6/7] iio: pressure: bmp280: Add data ready trigger support Vasileios Amoiridis
2024-09-03 14:36 ` Andy Shevchenko
2024-09-04 10:28 ` Vasileios Amoiridis
2024-09-04 14:19 ` Andy Shevchenko
2024-09-02 18:42 ` [PATCH v5 7/7] iio: pressure: bmp280: Move bmp085 interrupt to new configuration Vasileios Amoiridis
2024-09-03 14:39 ` Andy Shevchenko
2024-09-04 10:29 ` Vasileios Amoiridis
2024-09-03 14:36 ` [PATCH v5 0/7] pressure: bmp280: Minor cleanup and interrupt support Andy Shevchenko
2024-09-04 10:29 ` Vasileios Amoiridis
2024-09-07 16:35 ` Jonathan Cameron
2024-09-10 22:09 ` Vasileios Amoiridis
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20240904103223.GE44250@vamoiridPC \
--to=vassilisamir@gmail.com \
--cc=579lpy@gmail.com \
--cc=ak@it-klinger.de \
--cc=andriy.shevchenko@linux.intel.com \
--cc=ang.iglesiasg@gmail.com \
--cc=biju.das.jz@bp.renesas.com \
--cc=christophe.jaillet@wanadoo.fr \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=javier.carrasco.cruz@gmail.com \
--cc=jic23@kernel.org \
--cc=krzk+dt@kernel.org \
--cc=krzk@kernel.org \
--cc=lars@metafoo.de \
--cc=linus.walleij@linaro.org \
--cc=linux-iio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=robh@kernel.org \
--cc=semen.protsenko@linaro.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).