Re: [PATCH v2 0/3] iio: magnetometer: add support for the Allegro MicroSystems ALS31300 3-D Linear Hall Effect Sensor

[Jonathan Cameron <jic23@kernel.org>]

On Sat, 26 Oct 2024 18:26:43 +0100
Jonathan Cameron <jic23@kernel.org> wrote:

> On Mon, 21 Oct 2024 14:38:52 +0200
> Neil Armstrong <neil.armstrong@linaro.org> wrote:
> 
> > The Allegro MicroSystems ALS31300 is a 3-D Linear Hall Effect Sensor
> > mainly used in 3D sensing applications for head-on motion.
> > 
> > The device is configured over I2C, and as part of the Sensor
> > data the temperature core is also provided.
> > 
> > While the device provides an IRQ gpio, it depends on a configuration
> > programmed into the internal EEPROM, thus only the default mode
> > is supported and buffered input via trigger is also supported
> > to allow streaming values with the same sensing timestamp.
> > 
> > The device can be configured with different sensitivities in factory,
> > but the sensitivity value used to calculate value into the Gauss
> > unit is not available from registers, thus the sensitivity is
> > provided by the compatible/device-id string which is based
> > on the part number as described in the datasheet page 2.
> >     
> > The datasheet is available on the product website at [1].
> > 
> > [1] https://www.allegromicro.com/en/products/sense/linear-and-angular-position/linear-position-sensor-ics/als31300
> > 
> > Signed-off-by: Neil Armstrong <neil.armstrong@linaro.org>  
> Nice work. Applied to the togreg branch of iio.git and pushed out as testing
> to let 0-day take a first look at it.
And dropped again so you can respond to Andy's feedback.

Thanks,

Jonathan
> 
> Thanks,
> 
> Jonathan
>