[PATCH v3 06/10] dt-bindings: iio: accel: add interrupt-names

[Lothar Rubusch <l.rubusch@gmail.com>]

Add interrupt-names INT1 and INT2 for the two interrupt lines of the
sensor. Only one line will be connected for incoming events. The driver
needs to be configured accordingly. If no interrupt line is set up, the
sensor will still measure, but no events are possible.

Signed-off-by: Lothar Rubusch <l.rubusch@gmail.com>
---
 .../devicetree/bindings/iio/accel/adi,adxl345.yaml  | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/Documentation/devicetree/bindings/iio/accel/adi,adxl345.yaml b/Documentation/devicetree/bindings/iio/accel/adi,adxl345.yaml
index 280ed479ef5..c3483a4b652 100644
--- a/Documentation/devicetree/bindings/iio/accel/adi,adxl345.yaml
+++ b/Documentation/devicetree/bindings/iio/accel/adi,adxl345.yaml
@@ -37,6 +37,17 @@ properties:
   interrupts:
     maxItems: 1
 
+  interrupt-names:
+    Data ready is only available on INT1, but events can use either or
+    both pins.  If not specified, first element assumed to correspond
+    to INT1 and second (where present) to INT2.
+  minItems: 1
+  maxItems: 2
+  items:
+    enum:
+      - INT1
+      - INT2
+
 required:
   - compatible
   - reg
@@ -61,6 +72,7 @@ examples:
             reg = <0x2a>;
             interrupt-parent = <&gpio0>;
             interrupts = <0 IRQ_TYPE_LEVEL_HIGH>;
+            interrupt-names = "INT1";
         };
     };
   - |
@@ -79,5 +91,6 @@ examples:
             spi-cpha;
             interrupt-parent = <&gpio0>;
             interrupts = <0 IRQ_TYPE_LEVEL_HIGH>;
+            interrupt-names = "INT2";
         };
     };
-- 
2.39.5