devicetree.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: James Calligeros <jcalligeros99@gmail.com>
To: Liam Girdwood <lgirdwood@gmail.com>,
	Mark Brown <broonie@kernel.org>,
	 Jaroslav Kysela <perex@perex.cz>, Takashi Iwai <tiwai@suse.com>,
	 Shenghao Ding <shenghao-ding@ti.com>, Kevin Lu <kevin-lu@ti.com>,
	 Baojun Xu <baojun.xu@ti.com>, Dan Murphy <dmurphy@ti.com>,
	 Rob Herring <robh@kernel.org>,
	Krzysztof Kozlowski <krzk+dt@kernel.org>,
	 Conor Dooley <conor+dt@kernel.org>,
	Shi Fu <shifu0704@thundersoft.com>
Cc: "Alyssa Rosenzweig" <alyssa@rosenzweig.io>,
	"Martin Povišer" <povik+lin@cutebit.org>,
	"Hector Martin" <marcan@marcan.st>,
	linux-sound@vger.kernel.org, linux-kernel@vger.kernel.org,
	devicetree@vger.kernel.org, asahi@lists.linux.dev,
	"James Calligeros" <jcalligeros99@gmail.com>
Subject: [PATCH 27/27] ASoC: tas2770: Set the SDOUT polarity correctly
Date: Sat, 15 Feb 2025 10:03:00 +1000	[thread overview]
Message-ID: <20250215-apple-codec-changes-v1-27-723569b21b19@gmail.com> (raw)
In-Reply-To: <20250215-apple-codec-changes-v1-0-723569b21b19@gmail.com>

From: Hector Martin <marcan@marcan.st>

TX launch polarity needs to be the opposite of RX capture polarity, to
generate the right bit slot alignment.

Signed-off-by: Hector Martin <marcan@marcan.st>
Signed-off-by: James Calligeros <jcalligeros99@gmail.com>
---
 sound/soc/codecs/tas2770.c | 9 ++++++++-
 1 file changed, 8 insertions(+), 1 deletion(-)

diff --git a/sound/soc/codecs/tas2770.c b/sound/soc/codecs/tas2770.c
index a9e65f95ec8600d905c45db4e013d3c2602fa8dc..793a0df499a631d8e4670d4a452572b2dae0c477 100644
--- a/sound/soc/codecs/tas2770.c
+++ b/sound/soc/codecs/tas2770.c
@@ -358,7 +358,7 @@ static int tas2770_set_fmt(struct snd_soc_dai *dai, unsigned int fmt)
 	struct snd_soc_component *component = dai->component;
 	struct tas2770_priv *tas2770 =
 			snd_soc_component_get_drvdata(component);
-	u8 tdm_rx_start_slot = 0, invert_fpol = 0, fpol_preinv = 0, asi_cfg_1 = 0;
+	u8 tdm_rx_start_slot = 0, invert_fpol = 0, fpol_preinv = 0, asi_cfg_1 = 0, asi_cfg_4 = 0;
 	int ret;
 
 	switch (fmt & SND_SOC_DAIFMT_CLOCK_PROVIDER_MASK) {
@@ -375,6 +375,7 @@ static int tas2770_set_fmt(struct snd_soc_dai *dai, unsigned int fmt)
 		fallthrough;
 	case SND_SOC_DAIFMT_NB_NF:
 		asi_cfg_1 |= TAS2770_TDM_CFG_REG1_RX_RSING;
+		asi_cfg_4 |= TAS2770_TDM_CFG_REG4_TX_EDGE_FALLING;
 		break;
 	case SND_SOC_DAIFMT_IB_IF:
 		invert_fpol = 1;
@@ -393,6 +394,12 @@ static int tas2770_set_fmt(struct snd_soc_dai *dai, unsigned int fmt)
 	if (ret < 0)
 		return ret;
 
+	ret = snd_soc_component_update_bits(component, TAS2770_TDM_CFG_REG4,
+					    TAS2770_TDM_CFG_REG4_TX_EDGE_FALLING,
+					    asi_cfg_4);
+	if (ret < 0)
+		return ret;
+
 	switch (fmt & SND_SOC_DAIFMT_FORMAT_MASK) {
 	case SND_SOC_DAIFMT_I2S:
 		tdm_rx_start_slot = 1;

-- 
2.48.1


  parent reply	other threads:[~2025-02-15  0:06 UTC|newest]

Thread overview: 37+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2025-02-15  0:02 [PATCH 00/27] ASoC: tas27{64,70}: improve support for Apple codec variants James Calligeros
2025-02-15  0:02 ` [PATCH 01/27] ASoC: dt-bindings: tas27xx: add compatible for SN012776 James Calligeros
2025-02-15  0:02 ` [PATCH 02/27] ASoC: dt-bindings: tas2770: add compatible for TAS5770L James Calligeros
2025-02-15  0:02 ` [PATCH 03/27] ASoC: tas2764: Extend driver to SN012776 James Calligeros
2025-02-16 22:58   ` Alyssa Rosenzweig
2025-02-16 23:54     ` Mark Brown
2025-02-15  0:02 ` [PATCH 04/27] ASoC: tas2764: Add control concerning overcurrent events James Calligeros
2025-02-15  0:16   ` Martin Povišer
2025-02-15  0:02 ` [PATCH 05/27] ASoC: tas2770: Factor out set_ivsense_slots James Calligeros
2025-02-15  0:02 ` [PATCH 06/27] ASoC: tas2770: Fix and redo I/V sense TDM slot setting logic James Calligeros
2025-02-15  0:02 ` [PATCH 07/27] ASoC: tas2764: Reinit cache on part reset James Calligeros
2025-02-15  0:02 ` [PATCH 08/27] ASoC: tas2764: Configure zeroing of SDOUT slots James Calligeros
2025-02-15  0:02 ` [PATCH 09/27] ASoC: tas2764: Apply Apple quirks James Calligeros
2025-02-16 23:01   ` Alyssa Rosenzweig
2025-02-15  0:02 ` [PATCH 10/27] ASoC: tas2764: Raise regmap range maximum James Calligeros
2025-02-15  0:02 ` [PATCH 11/27] ASoC: tas2770: Export 'die_temp' to sysfs James Calligeros
2025-02-16 23:56   ` Mark Brown
2025-02-15  0:02 ` [PATCH 12/27] ASoC: tas2764: " James Calligeros
2025-02-15  0:02 ` [PATCH 13/27] ASoC: tas2764: Crop SDOUT zero-out mask based on BCLK ratio James Calligeros
2025-02-15  0:02 ` [PATCH 14/27] ASoC: tas2764: Enable main IRQs James Calligeros
2025-02-15  0:02 ` [PATCH 15/27] ASoC: tas2764: Power up/down amp on mute ops James Calligeros
2025-02-15  0:02 ` [PATCH 16/27] ASoC: tas2764: Add SDZ regulator James Calligeros
2025-02-15  0:02 ` [PATCH 17/27] ASoC: tas2764: Add reg defaults for TAS2764_INT_CLK_CFG James Calligeros
2025-02-15  0:02 ` [PATCH 18/27] ASoC: tas2764: Mark SW_RESET as volatile James Calligeros
2025-02-15  0:02 ` [PATCH 19/27] ASoC: tas2764: Fix power control mask James Calligeros
2025-02-16 23:58   ` Mark Brown
2025-02-15  0:02 ` [PATCH 20/27] ASoC: tas2764: Wait for ramp-down after shutdown James Calligeros
2025-02-15  0:02 ` [PATCH 21/27] ASoC: tas2770: Add SDZ regulator James Calligeros
2025-02-15  0:02 ` [PATCH 22/27] ASoC: tas2770: Power cycle amp on ISENSE/VSENSE change James Calligeros
2025-02-15  0:02 ` [PATCH 23/27] ASoC: tas2770: Add zero-fill and pull-down controls James Calligeros
2025-02-15  0:02 ` [PATCH 24/27] ASoC: tas2770: Support setting the PDM TX slot James Calligeros
2025-02-15  0:02 ` [PATCH 25/27] ASoC: tas2770: Fix volume scale James Calligeros
2025-02-17  0:00   ` Mark Brown
2025-02-15  0:02 ` [PATCH 26/27] ASoC: tas2764: Set the SDOUT polarity correctly James Calligeros
2025-02-15  0:03 ` James Calligeros [this message]
2025-02-15  0:39 ` [PATCH 00/27] ASoC: tas27{64,70}: improve support for Apple codec variants Neal Gompa
2025-02-16 23:03 ` Alyssa Rosenzweig

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20250215-apple-codec-changes-v1-27-723569b21b19@gmail.com \
    --to=jcalligeros99@gmail.com \
    --cc=alyssa@rosenzweig.io \
    --cc=asahi@lists.linux.dev \
    --cc=baojun.xu@ti.com \
    --cc=broonie@kernel.org \
    --cc=conor+dt@kernel.org \
    --cc=devicetree@vger.kernel.org \
    --cc=dmurphy@ti.com \
    --cc=kevin-lu@ti.com \
    --cc=krzk+dt@kernel.org \
    --cc=lgirdwood@gmail.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-sound@vger.kernel.org \
    --cc=marcan@marcan.st \
    --cc=perex@perex.cz \
    --cc=povik+lin@cutebit.org \
    --cc=robh@kernel.org \
    --cc=shenghao-ding@ti.com \
    --cc=shifu0704@thundersoft.com \
    --cc=tiwai@suse.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).