[PATCH v6 2/3] arm64: dts: imx95-19x19-evk: enable USB2.0 node

[Xu Yang <xu.yang_2@nxp.com>]

On this board, USB2.0 is a host-only port, add vbus regulator node
and enable USB2.0 node.

Reviewed-by: Frank Li <Frank.Li@nxp.com>
Signed-off-by: Xu Yang <xu.yang_2@nxp.com>

---
Changes in v6:
 - no changes
Changes in v5:
 - no changes
Changes in v4:
 - no changes
Changes in v3:
 - no changes
Changes in v2:
 - reorder regulator node
---
 .../arm64/boot/dts/freescale/imx95-19x19-evk.dts | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx95-19x19-evk.dts b/arch/arm64/boot/dts/freescale/imx95-19x19-evk.dts
index 25ac331f0318..a41d542488ed 100644
--- a/arch/arm64/boot/dts/freescale/imx95-19x19-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx95-19x19-evk.dts
@@ -145,6 +145,15 @@ reg_usdhc2_vmmc: regulator-usdhc2 {
 		off-on-delay-us = <12000>;
 	};
 
+	reg_usb_vbus: regulator-vbus {
+		compatible = "regulator-fixed";
+		regulator-name = "USB_VBUS";
+		regulator-min-microvolt = <5000000>;
+		regulator-max-microvolt = <5000000>;
+		gpio = <&i2c7_pcal6524 3 GPIO_ACTIVE_HIGH>;
+		enable-active-high;
+	};
+
 	sound-bt-sco {
 		compatible = "simple-audio-card";
 		simple-audio-card,name = "bt-sco-audio";
@@ -461,6 +470,13 @@ &sai3 {
 	status = "okay";
 };
 
+&usb2 {
+	dr_mode = "host";
+	disable-over-current;
+	vbus-supply = <&reg_usb_vbus>;
+	status = "okay";
+};
+
 &usb3 {
 	status = "okay";
 };
-- 
2.34.1