[PATCH v6 3/3] arm64: dts: imx95-15x15-evk: enable USB2.0 node

[Xu Yang <xu.yang_2@nxp.com>]

On this board, USB2.0 is a host-only port, add vbus regulator node
and enable USB2.0 node.

Signed-off-by: Xu Yang <xu.yang_2@nxp.com>

---
Changes in v6:
 - new patch
---
 .../arm64/boot/dts/freescale/imx95-15x15-evk.dts | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts b/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts
index 514f2429dcbc..aa0b9a4c3688 100644
--- a/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts
@@ -136,6 +136,15 @@ reg_usdhc3_vmmc: regulator-usdhc3 {
 		startup-delay-us = <20000>;
 	};
 
+	reg_usb_vbus: regulator-vbus {
+		compatible = "regulator-fixed";
+		regulator-name = "USB_VBUS";
+		regulator-min-microvolt = <5000000>;
+		regulator-max-microvolt = <5000000>;
+		gpio = <&pcal6524 3 GPIO_ACTIVE_HIGH>;
+		enable-active-high;
+	};
+
 	reg_vcc_12v: regulator-vcc-12v {
 		compatible = "regulator-fixed";
 		regulator-max-microvolt = <12000000>;
@@ -1023,6 +1032,13 @@ &tpm6 {
 	status = "okay";
 };
 
+&usb2 {
+	dr_mode = "host";
+	vbus-supply = <&reg_usb_vbus>;
+	disable-over-current;
+	status = "okay";
+};
+
 &usb3 {
 	status = "okay";
 };
-- 
2.34.1