[PATCH v2 2/6] arm64: dts: rockchip: move reset to dedicated eth-phy node on ringneck

[Heiko Stuebner <heiko@sntech.de>]

From: Heiko Stuebner <heiko.stuebner@cherry.de>

Using snps,reset-* properties to handle the ethernet-phy resets is
deprecated and instead a real phy node should be used.

Move the Ringneck phy-reset properties to such a node

Signed-off-by: Heiko Stuebner <heiko.stuebner@cherry.de>
Reviewed-by: Quentin Schulz <quentin.schulz@cherry.de>
Tested-by: Quentin Schulz <quentin.schulz@cherry.de>
---
 .../boot/dts/rockchip/px30-ringneck.dtsi      | 22 ++++++++++++++++---
 1 file changed, 19 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/boot/dts/rockchip/px30-ringneck.dtsi b/arch/arm64/boot/dts/rockchip/px30-ringneck.dtsi
index 142244d52706..ab232e5c7ad6 100644
--- a/arch/arm64/boot/dts/rockchip/px30-ringneck.dtsi
+++ b/arch/arm64/boot/dts/rockchip/px30-ringneck.dtsi
@@ -83,9 +83,7 @@ &emmc {
 
 /* On-module TI DP83825I PHY but no connector, enable in carrierboard */
 &gmac {
-	snps,reset-gpio = <&gpio3 RK_PB0 GPIO_ACTIVE_LOW>;
-	snps,reset-active-low;
-	snps,reset-delays-us = <0 50000 50000>;
+	phy-handle = <&dp83825>;
 	phy-supply = <&vcc_3v3>;
 	clock_in_out = "output";
 };
@@ -344,6 +342,18 @@ &io_domains {
 	status = "okay";
 };
 
+&mdio {
+	dp83825: ethernet-phy@0 {
+		compatible = "ethernet-phy-ieee802.3-c22";
+		reg = <0x0>;
+		pinctrl-names = "default";
+		pinctrl-0 = <&phy_rst>;
+		reset-assert-us = <50000>;
+		reset-deassert-us = <50000>;
+		reset-gpios = <&gpio3 RK_PB0 GPIO_ACTIVE_LOW>;
+	};
+};
+
 &pinctrl {
 	emmc {
 		emmc_reset: emmc-reset {
@@ -351,6 +361,12 @@ emmc_reset: emmc-reset {
 		};
 	};
 
+	ethernet {
+		phy_rst: phy-rst {
+			rockchip,pins = <3 RK_PB0 RK_FUNC_GPIO &pcfg_pull_none>;
+		};
+	};
+
 	leds {
 		module_led_pin: module-led-pin {
 			rockchip,pins = <1 RK_PB0 RK_FUNC_GPIO &pcfg_pull_none>;
-- 
2.47.2