[PATCH v2 1/5] thermal: airoha: Convert to regmap API

[Christian Marangi <ansuelsmth@gmail.com>]

In preparation for support of Airoha AN7583, convert the driver to
regmap API. This is needed as Airoha AN7583 will be based on syscon
regmap.

Signed-off-by: Christian Marangi <ansuelsmth@gmail.com>
---
 drivers/thermal/airoha_thermal.c | 72 +++++++++++++++++++-------------
 1 file changed, 42 insertions(+), 30 deletions(-)

diff --git a/drivers/thermal/airoha_thermal.c b/drivers/thermal/airoha_thermal.c
index 9a7a702a17de..04bda890dbb1 100644
--- a/drivers/thermal/airoha_thermal.c
+++ b/drivers/thermal/airoha_thermal.c
@@ -194,7 +194,7 @@
 #define AIROHA_MAX_SAMPLES			6
 
 struct airoha_thermal_priv {
-	void __iomem *base;
+	struct regmap *map;
 	struct regmap *chip_scu;
 	struct resource scu_adc_res;
 
@@ -265,8 +265,8 @@ static int airoha_thermal_set_trips(struct thermal_zone_device *tz, int low,
 			       RAW_TO_TEMP(priv, FIELD_MAX(EN7581_DOUT_TADC_MASK)));
 
 		/* We offset the high temp of 1°C to trigger correct event */
-		writel(TEMP_TO_RAW(priv, high) >> 4,
-		       priv->base + EN7581_TEMPOFFSETH);
+		regmap_write(priv->map, EN7581_TEMPOFFSETH,
+			     TEMP_TO_RAW(priv, high) >> 4);
 
 		enable_monitor = true;
 	}
@@ -277,15 +277,15 @@ static int airoha_thermal_set_trips(struct thermal_zone_device *tz, int low,
 			      RAW_TO_TEMP(priv, FIELD_MAX(EN7581_DOUT_TADC_MASK)));
 
 		/* We offset the low temp of 1°C to trigger correct event */
-		writel(TEMP_TO_RAW(priv, low) >> 4,
-		       priv->base + EN7581_TEMPOFFSETL);
+		regmap_write(priv->map, EN7581_TEMPOFFSETL,
+			     TEMP_TO_RAW(priv, high) >> 4);
 
 		enable_monitor = true;
 	}
 
 	/* Enable sensor 0 monitor after trip are set */
 	if (enable_monitor)
-		writel(EN7581_SENSE0_EN, priv->base + EN7581_TEMPMONCTL0);
+		regmap_write(priv->map, EN7581_TEMPMONCTL0, EN7581_SENSE0_EN);
 
 	return 0;
 }
@@ -302,7 +302,7 @@ static irqreturn_t airoha_thermal_irq(int irq, void *data)
 	bool update = false;
 	u32 status;
 
-	status = readl(priv->base + EN7581_TEMPMONINTSTS);
+	regmap_read(priv->map, EN7581_TEMPMONINTSTS, &status);
 	switch (status & (EN7581_HOFSINTSTS0 | EN7581_LOFSINTSTS0)) {
 	case EN7581_HOFSINTSTS0:
 		event = THERMAL_TRIP_VIOLATED;
@@ -318,7 +318,7 @@ static irqreturn_t airoha_thermal_irq(int irq, void *data)
 	}
 
 	/* Reset Interrupt */
-	writel(status, priv->base + EN7581_TEMPMONINTSTS);
+	regmap_write(priv->map, EN7581_TEMPMONINTSTS, status);
 
 	if (update)
 		thermal_zone_device_update(priv->tz, event);
@@ -336,11 +336,11 @@ static void airoha_thermal_setup_adc_val(struct device *dev,
 	/* sleep 10 ms for ADC to enable */
 	usleep_range(10 * USEC_PER_MSEC, 11 * USEC_PER_MSEC);
 
-	efuse_calib_info = readl(priv->base + EN7581_EFUSE_TEMP_OFFSET_REG);
+	regmap_read(priv->map, EN7581_EFUSE_TEMP_OFFSET_REG, &efuse_calib_info);
 	if (efuse_calib_info) {
 		priv->default_offset = FIELD_GET(EN7581_EFUSE_TEMP_OFFSET, efuse_calib_info);
 		/* Different slope are applied if the sensor is used for CPU or for package */
-		cpu_sensor = readl(priv->base + EN7581_EFUSE_TEMP_CPU_SENSOR_REG);
+		regmap_read(priv->map, EN7581_EFUSE_TEMP_CPU_SENSOR_REG, &cpu_sensor);
 		if (cpu_sensor) {
 			priv->default_slope = EN7581_SLOPE_X100_DIO_DEFAULT;
 			priv->init_temp = EN7581_INIT_TEMP_FTK_X10;
@@ -359,8 +359,8 @@ static void airoha_thermal_setup_adc_val(struct device *dev,
 static void airoha_thermal_setup_monitor(struct airoha_thermal_priv *priv)
 {
 	/* Set measure mode */
-	writel(FIELD_PREP(EN7581_MSRCTL0, EN7581_MSRCTL_6SAMPLE_MAX_MIX_AVG4),
-	       priv->base + EN7581_TEMPMSRCTL0);
+	regmap_write(priv->map, EN7581_TEMPMSRCTL0,
+		     FIELD_PREP(EN7581_MSRCTL0, EN7581_MSRCTL_6SAMPLE_MAX_MIX_AVG4));
 
 	/*
 	 * Configure ADC valid reading addr
@@ -375,15 +375,15 @@ static void airoha_thermal_setup_monitor(struct airoha_thermal_priv *priv)
 	 * We set valid instead of volt as we don't enable valid/volt
 	 * split reading and AHB read valid addr in such case.
 	 */
-	writel(priv->scu_adc_res.start + EN7581_DOUT_TADC,
-	       priv->base + EN7581_TEMPADCVALIDADDR);
+	regmap_write(priv->map, EN7581_TEMPADCVALIDADDR,
+		     priv->scu_adc_res.start + EN7581_DOUT_TADC);
 
 	/*
 	 * Configure valid bit on a fake value of bit 16. The ADC outputs
 	 * max of 2 bytes for voltage.
 	 */
-	writel(FIELD_PREP(EN7581_ADV_RD_VALID_POS, 16),
-	       priv->base + EN7581_TEMPADCVALIDMASK);
+	regmap_write(priv->map, EN7581_TEMPADCVALIDMASK,
+		     FIELD_PREP(EN7581_ADV_RD_VALID_POS, 16));
 
 	/*
 	 * AHB supports max 12 bytes for ADC voltage. Shift the read
@@ -391,40 +391,52 @@ static void airoha_thermal_setup_monitor(struct airoha_thermal_priv *priv)
 	 * in the order of half a °C and is acceptable in the context
 	 * of triggering interrupt in critical condition.
 	 */
-	writel(FIELD_PREP(EN7581_ADC_VOLTAGE_SHIFT, 4),
-	       priv->base + EN7581_TEMPADCVOLTAGESHIFT);
+	regmap_write(priv->map, EN7581_TEMPADCVOLTAGESHIFT,
+		     FIELD_PREP(EN7581_ADC_VOLTAGE_SHIFT, 4));
 
 	/* BUS clock is 300MHz counting unit is 3 * 68.64 * 256 = 52.715us */
-	writel(FIELD_PREP(EN7581_PERIOD_UNIT, 3),
-	       priv->base + EN7581_TEMPMONCTL1);
+	regmap_write(priv->map, EN7581_TEMPMONCTL1,
+		     FIELD_PREP(EN7581_PERIOD_UNIT, 3));
 
 	/*
 	 * filt interval is 1 * 52.715us = 52.715us,
 	 * sen interval is 379 * 52.715us = 19.97ms
 	 */
-	writel(FIELD_PREP(EN7581_FILT_INTERVAL, 1) |
-	       FIELD_PREP(EN7581_FILT_INTERVAL, 379),
-	       priv->base + EN7581_TEMPMONCTL2);
+	regmap_write(priv->map, EN7581_TEMPMONCTL2,
+		     FIELD_PREP(EN7581_FILT_INTERVAL, 1) |
+		     FIELD_PREP(EN7581_FILT_INTERVAL, 379));
 
 	/* AHB poll is set to 146 * 68.64 = 10.02us */
-	writel(FIELD_PREP(EN7581_ADC_POLL_INTVL, 146),
-	       priv->base + EN7581_TEMPAHBPOLL);
+	regmap_write(priv->map, EN7581_TEMPAHBPOLL,
+		     FIELD_PREP(EN7581_ADC_POLL_INTVL, 146));
 }
 
+static const struct regmap_config airoha_thermal_regmap_config = {
+	.reg_bits		= 32,
+	.reg_stride		= 4,
+	.val_bits		= 32,
+};
+
 static int airoha_thermal_probe(struct platform_device *pdev)
 {
 	struct airoha_thermal_priv *priv;
 	struct device_node *chip_scu_np;
 	struct device *dev = &pdev->dev;
+	void __iomem *base;
 	int irq, ret;
 
 	priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL);
 	if (!priv)
 		return -ENOMEM;
 
-	priv->base = devm_platform_ioremap_resource(pdev, 0);
-	if (IS_ERR(priv->base))
-		return PTR_ERR(priv->base);
+	base = devm_platform_ioremap_resource(pdev, 0);
+	if (IS_ERR(base))
+		return PTR_ERR(base);
+
+	priv->map = devm_regmap_init_mmio(dev, base,
+					  &airoha_thermal_regmap_config);
+	if (IS_ERR(priv->map))
+		return PTR_ERR(priv->map);
 
 	chip_scu_np = of_parse_phandle(dev->of_node, "airoha,chip-scu", 0);
 	if (!chip_scu_np)
@@ -462,8 +474,8 @@ static int airoha_thermal_probe(struct platform_device *pdev)
 	platform_set_drvdata(pdev, priv);
 
 	/* Enable LOW and HIGH interrupt */
-	writel(EN7581_HOFSINTEN0 | EN7581_LOFSINTEN0,
-	       priv->base + EN7581_TEMPMONINT);
+	regmap_write(priv->map, EN7581_TEMPMONINT,
+		     EN7581_HOFSINTEN0 | EN7581_LOFSINTEN0);
 
 	return 0;
 }
-- 
2.48.1