[PATCH v2 0/4] media: i2c: IMX355 for the Pixel 3a

[Richard Acayan <mailingradian@gmail.com>]

This adds support for the IMX355 in devicetree and adds support for the
Pixel 3a front camera.

This depends on https://lore.kernel.org/r/20250630224158.249726-2-mailingradian@gmail.com
because the GPIOs would go right next to the charging, if sorted
alphabetically.

Changes since v1 (20250630225944.320755-7-mailingradian@gmail.com):
- too much to have a complete list (1-4/4)
- squash camera orientation patch (4/4, previously 5/5)
- squash driver changes (2/4, previously 3/5)
- remove labelled endpoint node in sdm670.dtsi (3/4, 4/4)
- change init sequence to match other similar drivers (2/4)
- retrieve clock frequency from devicetree-defined clock (4/4)
- remove clock-frequency from dt-bindings (1/4)
- remove redundant descriptions of child nodes (1/4)
- switch initial drive of the reset GPIO to low (2/4)
- set mclk frequency to 19.2 MHz (4/4)
- add vdda-pll supply for camss (4/4)
- use common power on and off functions (2/4)
- use devm_clk_get_optional (2/4)
- remove extra layer when describing mclk pin (4/4)
- rename regulators (1/4, 2/4, 4/4)

Richard Acayan (4):
  dt-bindings: media: i2c: Add Sony IMX355
  media: i2c: imx355: Support devicetree and power management
  arm64: dts: qcom: sdm670: remove camss endpoint nodes
  arm64: dts: qcom: sdm670-google-sargo: add imx355 front camera

 .../bindings/media/i2c/sony,imx355.yaml       | 108 +++++++++++++
 .../boot/dts/qcom/sdm670-google-sargo.dts     | 116 ++++++++++++++
 arch/arm64/boot/dts/qcom/sdm670.dtsi          |  12 --
 drivers/media/i2c/imx355.c                    | 143 ++++++++++++++++--
 4 files changed, 355 insertions(+), 24 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/media/i2c/sony,imx355.yaml

-- 
2.50.1