[PATCH V3 2/4] ufs: ufs-qcom: Remove redundant re-assignment to hs_rate

[Ram Kumar Dwivedi <quic_rdwivedi@quicinc.com>]

Remove the redundant else block that assigns PA_HS_MODE_B to hs_rate,
as it is already assigned in ufshcd_init_host_params(). This avoids
unnecessary reassignment and prevents overwriting hs_rate when it is
explicitly set to a different value.

Signed-off-by: Ram Kumar Dwivedi <quic_rdwivedi@quicinc.com>
---
 drivers/ufs/host/ufs-qcom.c | 8 ++------
 1 file changed, 2 insertions(+), 6 deletions(-)

diff --git a/drivers/ufs/host/ufs-qcom.c b/drivers/ufs/host/ufs-qcom.c
index 9574fdc2bb0f..1a93351fb70e 100644
--- a/drivers/ufs/host/ufs-qcom.c
+++ b/drivers/ufs/host/ufs-qcom.c
@@ -494,12 +494,8 @@ static int ufs_qcom_power_up_sequence(struct ufs_hba *hba)
 	 * If the HS-G5 PHY gear is used, update host_params->hs_rate to Rate-A,
 	 * so that the subsequent power mode change shall stick to Rate-A.
 	 */
-	if (host->hw_ver.major == 0x5) {
-		if (host->phy_gear == UFS_HS_G5)
-			host_params->hs_rate = PA_HS_MODE_A;
-		else
-			host_params->hs_rate = PA_HS_MODE_B;
-	}
+	if (host->hw_ver.major == 0x5 && host->phy_gear == UFS_HS_G5)
+		host_params->hs_rate = PA_HS_MODE_A;
 
 	mode = host_params->hs_rate == PA_HS_MODE_B ? PHY_MODE_UFS_HS_B : PHY_MODE_UFS_HS_A;
 
-- 
2.50.1