[PATCH v4 6/6] arm64: dts: imx93-11x11-evk: Use phys to replace xceiver-supply

[Peng Fan <peng.fan@nxp.com>]

The TJA1057 used on i.MX93 EVK is actually high-speed CAN
transceiver, not a regulator supply. So use phys to reflect the truth.

Reviewed-by: Frank Li <Frank.Li@nxp.com>
Signed-off-by: Peng Fan <peng.fan@nxp.com>
---
 arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts | 17 ++++++++---------
 1 file changed, 8 insertions(+), 9 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts b/arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts
index e24e12f04526c3a08c0bdc6134297fb010e6e926..4c52f22bbfac99722184b4d8679f48c4396b557f 100644
--- a/arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts
@@ -62,6 +62,13 @@ vdevbuffer: vdevbuffer@a4020000 {
 
 	};
 
+	flexcan_phy: can-phy {
+		compatible = "nxp,tja1057", "ti,tcan1043";
+		#phy-cells = <0>;
+		max-bitrate = <5000000>;
+		standby-gpios = <&adp5585 6 GPIO_ACTIVE_HIGH>;
+	};
+
 	reg_vdd_12v: regulator-vdd-12v {
 		compatible = "regulator-fixed";
 		regulator-name = "VDD_12V";
@@ -87,14 +94,6 @@ reg_audio_pwr: regulator-audio-pwr {
 		enable-active-high;
 	};
 
-	reg_can2_standby: regulator-can2-standby {
-		compatible = "regulator-fixed";
-		regulator-name = "can2-stby";
-		regulator-min-microvolt = <3300000>;
-		regulator-max-microvolt = <3300000>;
-		gpio = <&adp5585 6 GPIO_ACTIVE_LOW>;
-	};
-
 	reg_m2_pwr: regulator-m2-pwr {
 		compatible = "regulator-fixed";
 		regulator-name = "M.2-power";
@@ -284,7 +283,7 @@ ethphy2: ethernet-phy@2 {
 &flexcan2 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_flexcan2>;
-	xceiver-supply = <&reg_can2_standby>;
+	phys = <&flexcan_phy>;
 	status = "okay";
 };
 

-- 
2.37.1