Re: [PATCH v2 1/2] dt-bindings: hwmon: Add support for ST TSC1641 power monitor

[Igor Reznichenko <igor@reznichenko.net>]

> Subject: I asked to drop "binding" and not add "support for". "Support
> for" makes little sense in terms of binding. How binding can support
> anything? This is the "ST TSC1641 power monitor" not support.

Krzysztof,

Thanks for feedback, will fix this and will create following patch versions
in new threads.

>> +
>> +  reg:
>> +    maxItems: 1
>> +
>> +  shunt-resistor-micro-ohms:
>> +    description: Shunt resistor value in micro-ohms. Since device has internal
>> +      16-bit RSHUNT register with 10 uOhm LSB, the maximum value is capped at
>> +      655.35 mOhm.
>> +    minimum: 100
>> +    default: 1000
>> +    maximum: 655350
>> +
>> +  st,alert-polarity-active-high:
>
>Isn't this just interrupt? You need proper interrupts property and then
>its flag define the type of interrupt.

This controls a bit written into device register.
I omitted interrupt property after looking at existing power monitor bindings,
especially hwmon/ti,ina2xx.yaml. INA226 has very similar bit controlling alert 
pin polarity and binding doesn't define alert pin as interrupt. Overall, I didn't
find many power monitor bindings defining alert pins as interrupts.

Thanks, Igor