Re: [PATCH net-next v3 04/12] net: dsa: lantiq_gswip: set link parameters also for CPU port

[Vladimir Oltean <olteanv@gmail.com>]

On Sun, Oct 26, 2025 at 11:44:24PM +0000, Daniel Golle wrote:
> On standalone switch ICs the link parameters of the CPU port need to
> be setup just like user ports. The destinction in the driver to not
> carry out link parameter setup for the CPU port does make sense for
> in-SoC switches on which the CPU port is internally connected to the
> SoC's Ethernet MAC.
> Set link parameters also for the CPU port unless it is an internal
> interface.
> 
> Signed-off-by: Daniel Golle <daniel@makrotopia.org>
> ---
>  drivers/net/dsa/lantiq/lantiq_gswip_common.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/net/dsa/lantiq/lantiq_gswip_common.c b/drivers/net/dsa/lantiq/lantiq_gswip_common.c
> index 092187603dea..0ac87eb23bb5 100644
> --- a/drivers/net/dsa/lantiq/lantiq_gswip_common.c
> +++ b/drivers/net/dsa/lantiq/lantiq_gswip_common.c
> @@ -1459,7 +1459,7 @@ static void gswip_phylink_mac_link_up(struct phylink_config *config,
>  	struct gswip_priv *priv = dp->ds->priv;
>  	int port = dp->index;
>  
> -	if (!dsa_port_is_cpu(dp)) {
> +	if (!dsa_port_is_cpu(dp) || interface != PHY_INTERFACE_MODE_INTERNAL) {
>  		gswip_port_set_link(priv, port, true);
>  		gswip_port_set_speed(priv, port, speed, interface);
>  		gswip_port_set_duplex(priv, port, duplex);
> -- 
> 2.51.1

PHY_INTERFACE_MODE_INTERNAL has two meanings: an internal MAC-to-MAC
connection or an internal PHY. In principle, your check excludes the
link parameter setup for CPU ports with internal PHYs. I had to check
that these don't exist, by looking at allowed_cpu_ports and seeing that
only the MII ports can be CPU ports. So this is OK, although being a bit
more explicit in the commit message would help, if you need to resend.

Reviewed-by: Vladimir Oltean <olteanv@gmail.com>