[PATCH v2 2/2] riscv: dts: spacemit: Add OrangePi R2S board device tree

[michael.opdenacker@rootcommit.com]

From: Michael Opdenacker <michael.opdenacker@rootcommit.com>

Add initial device tree support for the OrangePi RV2 board [1], which is
marketed as using the Ky X1 SoC but has been confirmed to be
identical to the SpacemiT K1 [2].

The device tree is similar to the OrangePi RV2 device tree
(k1-orangepi-rv2.dts).

This minimal device tree enables:

- booting into a serial console with UART.

- the two RGMII ethernet ports
  supporting Gigabit Ethernet operation.

  They have an external Motorcomm YT8531C PHY attached,
  the PHY uses GPIO for reset pin control. Their description
  was reused from the DTS from the OrangePi RV2 board.

- PDMA for the SpacemiT K1-based SoC.

- the 8 GB eMMC chip for storage.
  It works fine with the same description as
  on the BananaPi F3 board DTS.

Link: http://www.orangepi.org/html/hardWare/computerAndMicrocontrollers/details/Orange-Pi-R2S.html [1]
Link: https://www.spacemit.com/en/key-stone-k1 [2]

Signed-off-by: Michael Opdenacker <michael.opdenacker@rootcommit.com>
---
 arch/riscv/boot/dts/spacemit/Makefile         |  1 +
 .../boot/dts/spacemit/k1-orangepi-r2s.dts     | 90 +++++++++++++++++++
 2 files changed, 91 insertions(+)
 create mode 100644 arch/riscv/boot/dts/spacemit/k1-orangepi-r2s.dts

diff --git a/arch/riscv/boot/dts/spacemit/Makefile b/arch/riscv/boot/dts/spacemit/Makefile
index 942ecb38bea0..96b3a13a3944 100644
--- a/arch/riscv/boot/dts/spacemit/Makefile
+++ b/arch/riscv/boot/dts/spacemit/Makefile
@@ -3,3 +3,4 @@ dtb-$(CONFIG_ARCH_SPACEMIT) += k1-bananapi-f3.dtb
 dtb-$(CONFIG_ARCH_SPACEMIT) += k1-milkv-jupiter.dtb
 dtb-$(CONFIG_ARCH_SPACEMIT) += k1-musepi-pro.dtb
 dtb-$(CONFIG_ARCH_SPACEMIT) += k1-orangepi-rv2.dtb
+dtb-$(CONFIG_ARCH_SPACEMIT) += k1-orangepi-r2s.dtb
diff --git a/arch/riscv/boot/dts/spacemit/k1-orangepi-r2s.dts b/arch/riscv/boot/dts/spacemit/k1-orangepi-r2s.dts
new file mode 100644
index 000000000000..58098c4a2aab
--- /dev/null
+++ b/arch/riscv/boot/dts/spacemit/k1-orangepi-r2s.dts
@@ -0,0 +1,90 @@
+// SPDX-License-Identifier: (GPL-2.0 OR MIT)
+/*
+ * Copyright (C) 2025 Michael Opdenacker <michael.opdenacker@rootcommit.com>
+ */
+
+/dts-v1/;
+
+#include "k1.dtsi"
+#include "k1-pinctrl.dtsi"
+
+/ {
+	model = "OrangePi R2S";
+	compatible = "xunlong,orangepi-r2s", "spacemit,k1";
+
+	aliases {
+		serial0 = &uart0;
+		ethernet0 = &eth0;
+		ethernet1 = &eth1;
+	};
+
+	chosen {
+		stdout-path = "serial0";
+	};
+};
+
+&emmc {
+	bus-width = <8>;
+	mmc-hs400-1_8v;
+	mmc-hs400-enhanced-strobe;
+	non-removable;
+	no-sd;
+	no-sdio;
+	status = "okay";
+};
+
+&eth0 {
+	phy-handle = <&rgmii0>;
+	phy-mode = "rgmii-id";
+	pinctrl-names = "default";
+	pinctrl-0 = <&gmac0_cfg>;
+	rx-internal-delay-ps = <0>;
+	tx-internal-delay-ps = <0>;
+	status = "okay";
+
+	mdio-bus {
+		#address-cells = <0x1>;
+		#size-cells = <0x0>;
+
+		reset-gpios = <&gpio K1_GPIO(110) GPIO_ACTIVE_LOW>;
+		reset-delay-us = <10000>;
+		reset-post-delay-us = <100000>;
+
+		rgmii0: phy@1 {
+			reg = <0x1>;
+		};
+	};
+};
+
+&eth1 {
+	phy-handle = <&rgmii1>;
+	phy-mode = "rgmii-id";
+	pinctrl-names = "default";
+	pinctrl-0 = <&gmac1_cfg>;
+	rx-internal-delay-ps = <0>;
+	tx-internal-delay-ps = <250>;
+	status = "okay";
+
+	mdio-bus {
+		#address-cells = <0x1>;
+		#size-cells = <0x0>;
+
+		reset-gpios = <&gpio K1_GPIO(115) GPIO_ACTIVE_LOW>;
+		reset-delay-us = <10000>;
+		reset-post-delay-us = <100000>;
+
+		rgmii1: phy@1 {
+			reg = <0x1>;
+		};
+	};
+};
+
+&pdma {
+	status = "okay";
+};
+
+&uart0 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&uart0_2_cfg>;
+	status = "okay";
+};