[PATCH v4 3/5] arm64: dts: qcom: sdm670: remove camss endpoint nodes

[Richard Acayan <mailingradian@gmail.com>]

There is no need to add these by default for all of SDM670. Originally,
they were added so there could be a label for each port. This is
unnecessary if the endpoints are all added in a fixup to the camss node.

This is required since dcf6fb89e6f7 ("media: qcom: camss: remove a check
for unavailable CAMSS endpoint") was applied, forcing all endpoint nodes
to be probed, even if they are marked as disabled. According to the body
of this commit, there is "no valid or sane usecase".

Suggested-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Link: https://lore.kernel.org/r/488281f6-5e5d-4864-8220-63e2a0b2d7f2@linaro.org
Signed-off-by: Richard Acayan <mailingradian@gmail.com>
---
 arch/arm64/boot/dts/qcom/sdm670.dtsi | 12 ------------
 1 file changed, 12 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/sdm670.dtsi b/arch/arm64/boot/dts/qcom/sdm670.dtsi
index c33f3de779f6..c275089237e4 100644
--- a/arch/arm64/boot/dts/qcom/sdm670.dtsi
+++ b/arch/arm64/boot/dts/qcom/sdm670.dtsi
@@ -1768,26 +1768,14 @@ ports {
 
 				port@0 {
 					reg = <0>;
-
-					camss_endpoint0: endpoint {
-						status = "disabled";
-					};
 				};
 
 				port@1 {
 					reg = <1>;
-
-					camss_endpoint1: endpoint {
-						status = "disabled";
-					};
 				};
 
 				port@2 {
 					reg = <2>;
-
-					camss_endpoint2: endpoint {
-						status = "disabled";
-					};
 				};
 			};
 		};
-- 
2.52.0