[PATCH v8 5/7] arm64: dts: qcom: sdm670: label the camss ports instead of endpoints

[Richard Acayan <mailingradian@gmail.com>]

Endpoints cannot be pre-defined since dcf6fb89e6f7 ("media: qcom: camss:
remove a check for unavailable CAMSS endpoint") was applied, probing all
endpoint nodes and requiring them to have a remote. There is no sensible
remote in the SoC devicetree because camera sensors are board-specific.

The ports are meant to be extended by a board devicetree in order to
define fully configured endpoints and connect the ports to camera
sensors. For nodes that are only meaningful if extended, labels are
usually assigned. Label these ports so they can be extended directly.

Reviewed-by: Vladimir Zapolskiy <vladimir.zapolskiy@linaro.org>
Reviewed-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Signed-off-by: Richard Acayan <mailingradian@gmail.com>
---
 arch/arm64/boot/dts/qcom/sdm670.dtsi | 18 +++---------------
 1 file changed, 3 insertions(+), 15 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/sdm670.dtsi b/arch/arm64/boot/dts/qcom/sdm670.dtsi
index b8a8dcbdfbe3..3eb4eaf7b8d7 100644
--- a/arch/arm64/boot/dts/qcom/sdm670.dtsi
+++ b/arch/arm64/boot/dts/qcom/sdm670.dtsi
@@ -1776,28 +1776,16 @@ ports {
 				#address-cells = <1>;
 				#size-cells = <0>;
 
-				port@0 {
+				camss_port0: port@0 {
 					reg = <0>;
-
-					camss_endpoint0: endpoint {
-						status = "disabled";
-					};
 				};
 
-				port@1 {
+				camss_port1: port@1 {
 					reg = <1>;
-
-					camss_endpoint1: endpoint {
-						status = "disabled";
-					};
 				};
 
-				port@2 {
+				camss_port2: port@2 {
 					reg = <2>;
-
-					camss_endpoint2: endpoint {
-						status = "disabled";
-					};
 				};
 			};
 		};
-- 
2.53.0