[PATCH v2 4/4] arm64: dts: amlogic: meson-s4-s905y4-khadas-vim1s: add POWER key support

[Nick Xie <nick@khadas.com>]

Add the gpio-keys-polled node to support the Power button found on the
Khadas VIM1S board. The button is connected to the GPIOD_8 pin.

Use polled mode instead of gpio-keys because the GPIO interrupt
controller support for Meson S4 SoC is not yet available upstream.

Signed-off-by: Nick Xie <nick@khadas.com>
Reviewed-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
---
 .../dts/amlogic/meson-s4-s905y4-khadas-vim1s.dts     | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/arch/arm64/boot/dts/amlogic/meson-s4-s905y4-khadas-vim1s.dts b/arch/arm64/boot/dts/amlogic/meson-s4-s905y4-khadas-vim1s.dts
index 0bd738c1e7862..664d64a267f2d 100644
--- a/arch/arm64/boot/dts/amlogic/meson-s4-s905y4-khadas-vim1s.dts
+++ b/arch/arm64/boot/dts/amlogic/meson-s4-s905y4-khadas-vim1s.dts
@@ -6,6 +6,7 @@
 /dts-v1/;
 
 #include "meson-s4.dtsi"
+#include <dt-bindings/input/input.h>
 #include <dt-bindings/leds/common.h>
 
 / {
@@ -44,6 +45,17 @@ emmc_pwrseq: emmc-pwrseq {
 		reset-gpios = <&gpio GPIOB_9 GPIO_ACTIVE_LOW>;
 	};
 
+	gpio-keys-polled {
+		compatible = "gpio-keys-polled";
+		poll-interval = <100>;
+
+		power-button {
+			label = "power";
+			linux,code = <KEY_POWER>;
+			gpios = <&gpio GPIOD_8 GPIO_ACTIVE_LOW>;
+		};
+	};
+
 	pwm-leds {
 		compatible = "pwm-leds";
 
-- 
2.34.1