Re: [PATCH v2 2/6] arm64: dts: freescale: Add Verdin iMX95 support

[Francesco Dolcini <francesco@dolcini.it>]

On Tue, Mar 24, 2026 at 12:14:35PM -0400, Frank Li wrote:
> On Fri, Mar 13, 2026 at 09:57:43AM +0100, Ernest Van Hoecke wrote:
> > From: Ernest Van Hoecke <ernest.vanhoecke@toradex.com>
> >
> > Add support for the Toradex Verdin iMX95 and its development carrier
> > board.
> >
> > The module consists of an NXP i.MX95 family SoC, up to 16GB LPDDR4x RAM,
> > up to 128GB of storage, a USB 3.2 OTG and USB 2.0 Host, a Gigabit
> > Ethernet PHY, an I2C EEPROM and Temperature Sensor, an RX8130 RTC, an
> > I3C bus, one Quad lane CSI interface, one Quad lane DSI or CSI
> > interface, one LVDS interface (one or two channels), and some optional
> > addons: TPM 2.0, and a WiFi/BT module.
> >
> > Link: https://www.toradex.com/computer-on-modules/verdin-arm-family/nxp-imx95
> > Link: https://www.toradex.com/products/carrier-board/verdin-development-board-kit
> > Co-developed-by: Emanuele Ghidoli <emanuele.ghidoli@toradex.com>
> > Signed-off-by: Emanuele Ghidoli <emanuele.ghidoli@toradex.com>
> > Co-developed-by: Francesco Dolcini <francesco.dolcini@toradex.com>
> > Signed-off-by: Francesco Dolcini <francesco.dolcini@toradex.com>
> > Signed-off-by: Ernest Van Hoecke <ernest.vanhoecke@toradex.com>
> > ---
> > v2: Reordered nodes alphanumerically by node name
> > v1: https://lore.kernel.org/all/20260305-verdin-imx95-upstream-frank-li-base-v1-2-823fad02def9@toradex.com/
> > ---
> > +
> > +/* Verdin UART_1, connector X50 through RS485 transceiver */
> > +&lpuart7 {
> > +	rs485-rts-active-low;
> > +	rs485-rx-during-tx;
> > +	linux,rs485-enabled-at-boot-time;
> > +
> 
> Nit: needn't empty line between status and other property, suggest run
> https://github.com/lznuaa/dt-format to speed up process.

Please review Documentation/devicetree/bindings/dts-coding-style.rst.

Quoting from there
 > "status" (if applicable), preceded by a blank line if there is content before the property

I would be careful on taking every detail of such a style guide literally,
but your comment here is not correct and it's not helping anyone.

Francesco