Re: [PATCH phy-next 0/2] phy: ti: add driver for TI DS125DF111 Dual-Channel Retimer

[Vladimir Oltean <olteanv@gmail.com>]

On Wed, May 13, 2026 at 09:51:01PM +0300, Ioana Ciornei wrote:
> This patch set adds a generic PHY driver and the corresponding DT
> binding for the TI DS125DF111 Dual-Channel retimer. The datasheet on
> which this driver was based on can be found at -
> https://www.ti.com/lit/gpn/DS125DF111.
> 
> A separate generic PHY is registered for each of the two channels of the
> retimer, so consumers can drive each channel independently. This allows
> for independent control of the channels, which is especially important
> since each channel can be routed to different SerDes lanes and it is not
> guaranteed that the same retimer will do both directions of SerDes lane.
> 
> This was tested on a LS1088ARDB board with the Lynx10G SerDes PHY driver
> yet to be submitted.
> 
> Ioana Ciornei (2):
>   dt-bindings: phy: add PHY bindings for the TI DS125DF111 Retimer PHY
>   phy: ti: add PHY driver for TI DS125DF111 Dual-Channel Retimer
> 
>  .../bindings/phy/ti,ds125df111.yaml           |  46 ++++
>  drivers/phy/ti/Kconfig                        |  10 +
>  drivers/phy/ti/Makefile                       |   1 +
>  drivers/phy/ti/phy-ds125df111.c               | 245 ++++++++++++++++++
>  4 files changed, 302 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/phy/ti,ds125df111.yaml
>  create mode 100644 drivers/phy/ti/phy-ds125df111.c
> 
> -- 
> 2.25.1

When you resend, please add a MAINTAINERS entry for this driver.

Thanks!