[PATCH RFC v4 5/6] iio: osf: add UART transport

[Jinseob Kim <kimjinseob88@gmail.com>]

Use the generic Open Sensor Fusion compatible.

Avoid board-specific DT compatibles.

Signed-off-by: Jinseob Kim <kimjinseob88@gmail.com>
---
 drivers/iio/opensensorfusion/Kconfig      | 4 ++--
 drivers/iio/opensensorfusion/osf_serdev.c | 2 +-
 2 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/iio/opensensorfusion/Kconfig b/drivers/iio/opensensorfusion/Kconfig
index 957caed2b..8b9376d28 100644
--- a/drivers/iio/opensensorfusion/Kconfig
+++ b/drivers/iio/opensensorfusion/Kconfig
@@ -10,5 +10,5 @@ config OPEN_SENSOR_FUSION
 	help
 	  Build the Open Sensor Fusion UART IIO driver.
 
-	  The driver receives OSF0 frames over a serdev UART and registers
-	  IIO devices for supported capability entries.
+	  The driver receives OSF protocol frames over a serdev UART and
+	  registers IIO devices for supported capability entries.
diff --git a/drivers/iio/opensensorfusion/osf_serdev.c b/drivers/iio/opensensorfusion/osf_serdev.c
index 1ac93548d..fd36acd1b 100644
--- a/drivers/iio/opensensorfusion/osf_serdev.c
+++ b/drivers/iio/opensensorfusion/osf_serdev.c
@@ -91,7 +91,7 @@ static void osf_serdev_remove(struct serdev_device *serdev)
 }
 
 static const struct of_device_id osf_serdev_of_match[] = {
-	{ .compatible = "opensensorfusion,osf-green" },
+	{ .compatible = "opensensorfusion,osf" },
 	{ }
 };
 MODULE_DEVICE_TABLE(of, osf_serdev_of_match);
-- 
2.43.0