[PATCH] arm64: dts: qcom: sc8280xp-huawei-gaokun3: Add dsi panel DT node

[Pengyu Luo <mitltlatltl@gmail.com>]

DSI panel driver have been added for a while, so add the DT node to
enable it. vdd{a,s}-supply for dsi, dsi_phy are blank since the DSDT
describes the wrong, no impact after manual disabling these wrong
supplies.

Signed-off-by: Pengyu Luo <mitltlatltl@gmail.com>
---
 .../boot/dts/qcom/sc8280xp-huawei-gaokun3.dts | 165 ++++++++++++++++++
 1 file changed, 165 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sc8280xp-huawei-gaokun3.dts b/arch/arm64/boot/dts/qcom/sc8280xp-huawei-gaokun3.dts
index f3c00be67081..658bb253394a 100644
--- a/arch/arm64/boot/dts/qcom/sc8280xp-huawei-gaokun3.dts
+++ b/arch/arm64/boot/dts/qcom/sc8280xp-huawei-gaokun3.dts
@@ -11,6 +11,7 @@
 
 /dts-v1/;
 
+#include <dt-bindings/clock/qcom,dsi-phy-28nm.h>
 #include <dt-bindings/iio/qcom,spmi-adc7-pm8350.h>
 #include <dt-bindings/gpio/gpio.h>
 #include <dt-bindings/input/gpio-keys.h>
@@ -98,6 +99,52 @@ switch-mode {
 		};
 	};
 
+	vreg_avdd_5p5: regulator-avdd-5p5 {
+		compatible = "regulator-fixed";
+
+		regulator-name = "vreg_avdd_5p5";
+		regulator-min-microvolt = <5500000>;
+		regulator-max-microvolt = <5500000>;
+
+		gpio = <&tlmm 53 GPIO_ACTIVE_HIGH>;
+		enable-active-high;
+
+		pinctrl-0 = <&avdd_reg_en>;
+		pinctrl-names = "default";
+
+		regulator-boot-on;
+	};
+
+	vreg_avee_5p5: regulator-avee-5p5 {
+		compatible = "regulator-fixed";
+
+		regulator-name = "vreg_avee_5p5";
+		regulator-min-microvolt = <5500000>;
+		regulator-max-microvolt = <5500000>;
+
+		gpio = <&tlmm 52 GPIO_ACTIVE_HIGH>;
+		enable-active-high;
+
+		pinctrl-0 = <&avee_reg_en>;
+		pinctrl-names = "default";
+
+		regulator-boot-on;
+	};
+
+	vreg_vddi_1p8: regulator-vddi-1p8 {
+		compatible = "regulator-fixed";
+
+		regulator-name = "vreg_vddi_1p8";
+
+		gpio = <&tlmm 0 GPIO_ACTIVE_HIGH>;
+		enable-active-high;
+
+		pinctrl-0 = <&vddi_reg_en>;
+		pinctrl-names = "default";
+
+		regulator-boot-on;
+	};
+
 	vreg_misc_3p3: regulator-misc-3p3 {
 		compatible = "regulator-fixed";
 
@@ -616,6 +663,9 @@ touchscreen@4f {
 		hid-descr-addr = <0x1>;
 		interrupts-extended = <&tlmm 175 IRQ_TYPE_LEVEL_LOW>;
 
+		/* TODO: set post-reset-deassert-delay-ms */
+		panel = <&panel>;
+
 		vdd-supply = <&vreg_misc_3p3>;
 		vddl-supply = <&vreg_s10b>;
 
@@ -738,6 +788,86 @@ &mdss0_dp1_out {
 	remote-endpoint = <&usb_1_qmpphy_dp_in>;
 };
 
+&mdss0_dsi0 {
+	/* real vdda is unknown */
+
+	qcom,dual-dsi-mode;
+	qcom,master-dsi;
+	qcom,sync-dual-dsi;
+
+	status = "okay";
+
+	panel: panel@0 {
+		compatible = "csot,ppc357db1-4", "himax,hx83121a";
+		reg = <0>;
+
+		pinctrl-0 = <&disp_reset_n>, <&mdp_vsync_default>;
+		pinctrl-names = "default";
+
+		reset-gpios = <&tlmm 38 GPIO_ACTIVE_LOW>;
+
+		vddi-supply = <&vreg_vddi_1p8>;
+		avdd-supply = <&vreg_avdd_5p5>;
+		avee-supply = <&vreg_avee_5p5>;
+
+		ports {
+			#address-cells = <1>;
+			#size-cells = <0>;
+
+			port@0 {
+				reg = <0>;
+
+				panel_in_0: endpoint {
+					remote-endpoint = <&mdss0_dsi0_out>;
+				};
+			};
+
+			port@1 {
+				reg = <1>;
+
+				panel_in_1: endpoint {
+					remote-endpoint = <&mdss0_dsi1_out>;
+				};
+			};
+		};
+	};
+};
+
+&mdss0_dsi0_out {
+	data-lanes = <0 1 2 3>;
+	remote-endpoint = <&panel_in_0>;
+};
+
+&mdss0_dsi0_phy {
+	/* real vdds is unknown */
+
+	status = "okay";
+};
+
+&mdss0_dsi1 {
+	/* real vdda is unknown */
+
+	qcom,dual-dsi-mode;
+	qcom,sync-dual-dsi;
+
+	status = "okay";
+
+	/* DSI1 is slave, so use DSI0 clocks */
+	assigned-clock-parents = <&mdss0_dsi0_phy DSI_BYTE_PLL_CLK>,
+				 <&mdss0_dsi0_phy DSI_PIXEL_PLL_CLK>;
+};
+
+&mdss0_dsi1_out {
+	data-lanes = <0 1 2 3>;
+	remote-endpoint = <&panel_in_1>;
+};
+
+&mdss0_dsi1_phy {
+	/* real vdds is unknown */
+
+	status = "okay";
+};
+
 &pcie2a {
 	perst-gpios = <&tlmm 143 GPIO_ACTIVE_LOW>;
 	wake-gpios = <&tlmm 145 GPIO_ACTIVE_LOW>;
@@ -1303,6 +1433,20 @@ &tlmm {
 
 	gpio-reserved-ranges = <70 2>, <74 6>, <83 4>, <125 2>, <128 2>, <154 4>;
 
+	avdd_reg_en: avdd-reg-en-state {
+		pins = "gpio53";
+		function = "gpio";
+		drive-strength = <2>;
+		bias-disable;
+	};
+
+	avee_reg_en: avee-reg-en-state {
+		pins = "gpio52";
+		function = "gpio";
+		drive-strength = <2>;
+		bias-disable;
+	};
+
 	bt_default: bt-default-state {
 		hstp-bt-en-pins {
 			pins = "gpio133";
@@ -1318,6 +1462,20 @@ hstp-sw-ctrl-pins {
 		};
 	};
 
+	disp_reset_n: disp-reset-n-state {
+		pins = "gpio38";
+		function = "gpio";
+		drive-strength = <2>;
+		bias-pull-up;
+	};
+
+	mdp_vsync_default: mdp-vsync-default-state {
+		pins = "gpio8";
+		function = "mdp_vsync";
+		drive-strength = <2>;
+		bias-disable;
+	};
+
 	i2c4_default: i2c4-default-state {
 		pins = "gpio171", "gpio172";
 		function = "qup4";
@@ -1470,6 +1628,13 @@ usb1_sbu_default: usb1-sbu-state {
 		bias-disable;
 	};
 
+	vddi_reg_en: vddi-reg-en-state {
+		pins = "gpio0";
+		function = "gpio";
+		drive-strength = <2>;
+		bias-disable;
+	};
+
 	wcd_default: wcd-default-state {
 		reset-pins {
 			pins = "gpio106";
-- 
2.54.0